DHS100 Cordless Headset User's Guide
What's in the box?
Cordless
headset with
Headband
ear loop
and ear cap
attached
Charge cradle
Additional
earpiece loops (2)
x If any items are missing or damaged, contact our Customer Care
Line immediately. Never use damaged products!
x Need Help? Get answers 24/7 at our website: www.uniden.com.
If You... Contact Uniden’s... Phone Number
have a question or problem Customer Care Line*
need a part or accessory Parts Department* 800-554-3988
need special assistance due
to a disability
* During regular business hours, Central Sta ndard Time. Visit our website for detailed
business hours.
Accessibility Help Line
Important Safety Instructions!
When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of re, electric shock and injury to persons, including the
following:
x is unit is NOT waterproof. DO NOT expose this unit to rain or moisture.
x Do not use this product near water, for example, near a bath tub, wash bowl, kitchen
sink or laundry tub, in a wet basement or near a swimming pool.
x Avoid using a telephone (other than a cordless type) during an electrical storm. ere
may be a remote risk of electric shock from lightning.
x Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE I NSTRUCTION S!
PREPARING YOUR HEADSET
Attach Earpiece Loop or Headband
x Choose the appropriate size Earpiece Loop.
x Push the selected Earpiece Loop or Headband
eyelet onto headset mounting peg.
Charge the Battery
1. Connect the AC adapter to the
charge cradle jack and to a wall
outlet.
2. Place the headset in the charging
cradle with the status LED
facing forward. If the LED
doesn’t light up, reseat the
headset or connect the charger
to a different outlet.
3. When the headset is fully charged, the status LED will show blue.
#Charge the headset completely (about 3 hours) before using it.
#Do not charge the headset when the ambient temperature is below
0° C (32°F) or above 40°C (104°F).
MUT E/ FLA SH
STATUS L ED
AC adapter
(PS-0045)
Additional ear caps (2)
817-858-2929 or
800-297-1023
800-874-9314
(voice or TTY)
Flash
Mute
Earloop
Headset peg
Earloop
eyelet
ON/ OF F/TA LK
VOL UM E + /-
REGISTERING TO A BASE
#The accessory headset won't work until you register it to a
compatible Uniden cordless phone!
Compatible Uniden Cordless Phones
Find compatible models at our website: www.uniden.com.
Register the Headset
1. On the phone base, press and hold
#On some models (such as the D3588) press
from the display menu selection, and then press
2. On the headset, press and hold both
The status LED alternately blinks slow to fast blue and red while registering.
When registered, a confirmation tone sounds at the phone base and the
headset LED flashes blue once every 10 seconds.
Test the connection
Pick up the headset and press
OFF/TAlK
to hang up.)
If... Try...
x there is no dial tone
x the error tone sounds
FIND HANDSET
VOlUME -
ON/OFF/TAlK
for 5 seconds.
MENU
, select Register handset
SElEcT.
and + for 5 seconds.
. Listen for a dial tone. (Press
charging the headset until fully
charged and then retry connection.
ON/
OPERATION
To power on... To power off...
x press and hold
.
seconds
ON/OFF/TAlK
for 3
x press and hold
seconds
.
ON/OFF/TAlK
for 3
To answer a call... To adjust call or ringer volume...
x press
x press
ON/OFF/TAlK
ON/OFF/TAlK
and speak clearly
again to end call
call (in use) or ringer (standby):
x press + to increase or – to decrease
To mute the microphone... To answer call waiting call...
x press
x press
MUTE/FlASH
MUTE/FlASH
to mute
again to unmute
x press and hold
x press and hold
MUTE/FlASH
MUTE/FlASH
to return
IMPORTANT INFORMATION
AC Adapter and Battery Specications
AC adapte r
Part number Input voltage Output voltage
PS-0 045 120VAC, 60 Hz 5.4VDC @ 400mA
x Use only the supplied AC adapter.
x Do not place the unit in direct sunlight or subject it to high temperatu res.
Batte ry informati on (battery is n ot user-replaceab le)
Type Capacity Talk time Standby time
Lithium- ion 230mAh, 3.7 VDC about 6 hours about 3 days
x Please contact Uniden Customer Ser vice if the battery fails.
x When the battery gets low, the headset sounds an alert tone and t he status indicator shows red
once every 10 seconds to indicate the unit needs cha rging.
General InformatIon
• You cannot use the headset while it is charging.
• Actual range varies depending environmental conditions and bat tery power level.
Cleaning the headset
If necessar y, remove the Ear Cap and Ear piece loop. Dampen a lint-free cloth with water or
a cleaner specially designed for elec tronics, and gently wipe the headset clean.
Do not expose this product to liquid (water, alcohol, etc.) or
submerse in liquid for any reason.
Compliance Information
Any changes or modications to t his product not expressly approved by the manufacturer
or other pa rty responsible for compliance could void you r authority to operate this produc t.
FCC Part 15 Information
is device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) is device may not cause harmful i nterference, and (2) is device
must accept any interference received, including inter ference that may cause undesired
operation. Privacy of communications may not be ensured when using this phone.
FCC PART 15.105(b): Note: is equipment has been tested and found to comply w ith
the limits for a Class B digital dev ice, pursuant to part 15 of the FCC Ru les. ese limits
are designed to provide reasonable protection against harmful interference in a residential
installation. is equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance wit h the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference wil l not occur in
a part icular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, t he user is
encouraged to try to correct the inter ference by one or more of the following measures:
x Reorient or relocate the receiving antenna.
x Increase the separation between t he equipment and receiver.
x Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
x Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
is product complies wit h FCC radiation exposure limits under the following conditions:
x e base must be placed to al low a minimum of 20 cm (8 inches) between the antenna and a ll
persons during normal operat ion.
x e base must not be col located or operated in conjunction with any other antenna or tra ns-
mitter.
x e headset is designed for body-worn operation and meets FCC RF exposure guidelines when
used with any belt clip, carr ying case, or other accessory supplied with this product. (All necessary accessories are included in the package; any additional or optional accessories a re not
required for compliance w ith the guidelines.) ird party accessories (unless approved by the
manufacturer) should be avoided as these m ight not comply with FCC RF exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: is equipment meets the applicable Industry Canada Terminal Equipment
Technical Speci cations. is is conrmed by t he registration number. e abbreviation IC
before the registration number signies that registration was performed based on a Declaration of Conformity indicat ing that Industry Canada technical speci cations were met. It
does not imply that Industry Ca nada approved the equipment.
NOTICE: e R inger Equiva lence Number (REN) for this termina l equipment is marked
on the equipment itself. e R EN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface.
e termination on an interface may consist of any combination of devices subject only to
the requirement t hat the sum of the R inger Equiva lence Numbers of all the devices does not
exceed 5.
Radio equipment
e term IC before the radio cer tication number only signies that Industry Canada
technical specications were met. Operation is subject to t he following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. "Privacy of communications may not be ensured when using this telephone".
One-year Limited Warranty
Evidence of original purchase is required for warrant y service.
WARRANTOR: U NIDEN AMERICA COR PORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner,
this Uniden Product to be free from defects in materials and crasmanship with only the
limitations or exclusions set out below.
WARRANTY DURATION: is warrant y to the original user shal l terminate and be of
no further eect 12 months aer the date of origina l retail sale. e warranty is invalid if
the Product is (A) damaged or not maintained as reasonable or necessary, (B) modied,
altered, or used as par t of any conversion kits, subassemblies, or any congurations not sold
by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an
authori zed Uniden serv ice center for a defect or malfunction covered by this warrant y, (E)
used in any conjunction w ith equipment or parts or as part of any system not manufactured
by Uniden, or (F) insta lled or programmed by anyone other than as detailed by the owner's
manual for this product.
STATEMENT OF REMEDY: In the event that the product does not conform to t his warranty at any t ime while this warrant y is in eect, warrantor will eit her, at its option, repair or
replace t he defective unit and return it to you without charge for parts, serv ice, or any other
cost (except shipping and handling) incurred by warrantor or its representatives in connection wit h the performa nce of this warranty. Warrantor, at its option, may replace t he unit
with a new or refurbished unit. THE LIMITED WARRANT Y SET FORTH ABOVE IS THE
SOLE AND ENTIRE WARRAN TY PERTAINING TO THE PRODUCT AND IS IN LIEU
OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WH ATSOEVER,
WHETHER EXPRESS, IMPLIED OR AR ISING BY OPERATION OF LAW, INCLUDING,
BUT NOT LIMITED TO ANY IMPLIED WARR ANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. THIS WARR ANTY DOES NOT COVER OR
PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF I NCIDENTAL OR CONSEQUENTIAL DAM AGES. Some states do not allow this exclusion or limitation of incidental
or consequential damages so t he above limitation or exclusion may not apply to you.
LEGAL REMEDIES: is wa rranty gives you specic legal rights, a nd you may also have
other rights which vary from state to state. is warranty is void outside the United States
of America and Canada.
PROCEDUR E FOR OBTAINING PER FORMANCE OF WARR ANTY: If, aer following
the instructions in the ow ner's manual you are certain that the Product is defective, pack
the Product carefully (preferably in its origina l packaging). Disconnect the battery f rom the
Product and separately secure the battery in its own separate packaging within the shipping
carton. e Product should include all parts and accessories originally packaged with the
Product. Include evidence of origina l purchase and a note describing t he defect that has
caused you to return it. e Product should be shipped freight prepaid, by traceable means,
to warrantor at:
Uniden America Service
4700 Amon C arter Blvd.
Fort Worth, TX 76155
x Uniden® is a registered trade-
mark of Uniden America
Corporation.
x Call waiting, CID, CIDCW,
and Voice Mail are telephone line services. Your phone supports these
services, but you have to arrange for them through your telephone provider. Contact your provider for details.
x e pictures in t his manual are for exa mple only. Your phone may not look exactly like the
pictures.
As an Energy Star® Par tner, Uniden
has determined that this produc t
meets the Energy Star® guidelines for
energy e ciency. Energy Star® is a U.S.
registered mark.
© 2012 Uniden America Corp. Printed in Vietnam
Fort Worth, Texas U01UU260BZA(0)