
UH041/
UH041P
Operating Guide
To bring outstanding wireless communication products
to people's lives throughout the world.
volume
channel/
scan
dup mon
hi/lo
volume
channel/
scan
dup mon
hi/lo
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:17 PM
Color profile: Disabled
Composite Default screen

CONTROL & INDICATORS
1 Antenna
2 PTT (Push-To-Talk) Button
3 Channel/scan up Key
4 Channel/scan down Key
5 Duplex/Transmit Hi/Lo
6 Speaker
7 Power On/Off/Select Key
8 Monitor Key
9 Volume up Key
10 Volume down Key
11 Battery Compartment Door
1
INCLUDED IN YOUR PACKAGE:
Please check which model you have - UH041 or UH041P.
!
!
!
UH041 Radio
Operating Guide
Belt Clip
UH041 UH041P
!
!
!
!
!
UH041P Radio (2)
Operating Guide
Belt Clip (2)
Charging Cradle with
AC Adaptor
NiMH Battery Pack (2)
12 Channel Indicator
13 Receive Indicator
1415Transmit Indicator
Battery Indicator
16 Scan Indicator
17 Vox on Indicator
18 Key lock setting Indicator
19 Volume setting Indicator
20 Duplex Indicator
21 TX Hi Indicator
22 CTCSS channel indicator
RX TX
VOL
DUP
HI
SCAN
VOX
12
17
22
16
18
21
20
19
1413 15
volume
channel/
scan
dup mon
!
!
!
Charging Cradle with AC
Adaptor
NiMH Battery Pack
VOX Earset
OPTIONAL ACCESSORIES
RX TX
VOL
DUP
HI
SCAN
VOX
hi/lo
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:20 PM
Color profile: Disabled
Composite Default screen

Your radio uses 4 AAA ALKALINE or optional
NiMH battery pack (UH041P includes NiMH battery pack)
batteries for power.
UH041/UHO41P
GETTING STARTED
To avoid damage to the unit do not mix
old and new batteries.
To install the batteries:
1. Make sure your radio is off.
2. Remove the battery
compartment door by pressing
the tab at the bottom of the
compartment door allowing the
door to be removed.
3. Insert 4 AAA ALKALINE batteries
according to the polarity
symbols inside the battery
compartment.
4. Replace the battery cover.
BATTERY INSTALLATION
2
Uniden does not represent this product to be
waterproof. Do not expose this product to Rain
or Moisture.
INSTALLING THE CHARGE CRADLE (UH041P only)
!
!
Install the NiMH Battery Pack as per above instructions.
Plug the AC Adaptor into the rear of the charge cradle and
into the mains power.
Do not charge alkaline or non
rechargeable batteries.
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:20 PM
Color profile: Disabled
Composite Default screen

If the Battery level becomes low, the battery
indicator icon on the LCD begins flashing..
LOW BATTERY ALERT
When the batteries in the unit are low, the unit will go into a
Battery Low Mode. The Transmit Mode is disabled. Replace the
alkaline batteries immediately or if you are using the NiMH
Battery pack, place the Radio on the charge cradle to recharge
(supplied with , optional accessory for to
continue using the radio.
UHO41P UH041)
3
To attach the belt clip:
To remove the belt clip:
Slide the belt clip until it snaps into place.
To remove the belt clip. Press and hold
belt clip locker, slide the belt clip at the
same time until released.
BELT CLIP
Belt Clip Locker
Place the UH041P into the charge cradle. The charge light will
come on to indicate the unit is charging. Before operating the
UH041P, charge the battery pack for 16 hours.
Power Point
charge 1 charge 2
volume
channel/
scan
dup mon
Do not charge alkaline or non
rechargeable batteries.
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:22 PM
Color profile: Disabled
Composite Default screen