Uniden TCX860 User Manual

TCX 860

Accessory Handset

OWNER'S

MANUAL

Welcome

Congratulations on your purchase of the Uniden TCX860 optional
handset and charger. This expansion handset is for use with the Two
Line Digital Expandable TRU8866 series (model numbers may vary).
Each model within this series will support up to ten handsets. It
functions as a 2-line telephone system if you subscribe to two phone
lines. You can place a fully featured cordless handset anywhere in your
home as long as you have AC power is available to connect the handset
charging cradle.

IMPORTANT

The TCX860 expansion handset will not operate unless it has been
registered to your main base. This manual describes how to set up and
connect your new handset; for instructions on operating your new
handset, refer to the owner's manual supplied with your main base.

To purchase expansion handsets (TCX860), visit our web site at
www.uniden.com.

Checking the Package Contents

Make sure you have received the following items in the package.
If any of these items are missing or damaged, contact the Uniden
Parts Department.

•Cordless Handset

•Charging Cradle

• Battery Pack (BT-446)
(Capacity: 800 mAH, 3.6V)

• AC Adapter (AD-0005)
(INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA)

•Beltclip

• This Owner’s Manual

• Other Printed Material

Uniden Parts Department at [phone]

Hours: M-F 8:00 a.m. to 5:00 p.m. CST.

or visit our website at

www.uniden.com

– 2 –

Installing Your Expansion Handset

Follow these three easy steps to get your new handset ready to use:

Install the battery pack.

1

Connect the charger and charge your new handset for 15-20 hours.

2

Register your new handset to the main base.

3

Step 1: Install the Battery Pack

Press down on the handset battery

1

case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.

Plug the battery pack connector

2

(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment, and
push the connector in until you hear
a click.

Make sure you have a good connection

3

by slightly pulling on the battery
wires. If the connection is secure, the
battery jack will remain in place.

Place the battery case cover back on

4

the handset by sliding it upwards
until it clicks into place.

Place the handset in the charging

5

cradle with the keypad facing
forward.

• Use only the Uniden battery (BT-446)
supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department. (See
page 2.)

• Recharge your handset on a regular basis by
returning the handset to the charger after each
phone call.

Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly

– 3 –

Step 2: Connect the Charger

Connect the AC adapter to the

1

DC IN 9V jack and to a standard
120V AC wall outlet.
Set the charger on a desk or

2

tabletop, and place the handset
in the charger with the keypad
facing forward.
Make sure the

3

illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and that
the handset makes good contact with the charger charging contacts.

• Use only the supplied AD-0005 AC adapter. Do not use

• Place the charger close to the AC outlet so that you can

charge

LED

any other AC adapter.

unplug the AC adapter easily.

4 Charge the handset for 15-20 hours before using.

Step 3: Register the Handset

YOU NEED TO REGISTER THE TCX860 TO THE MAIN BASE BEFORE USE!

Be sure the handset battery is

1

fully charged.
With the main base in standby

2

mode (i.e., not being used),
place the expansion handset in
the main base to begin
registration.
While the handset is

3

registering,

Registering

the handset LCD. When

Registration Complete

displayed, the handset has
been registered to the base.

Registration Failed

If
appears, please try these steps
again.

Handset

will appear in

1

TCX860
Handset

Charger

2

Place the TCX860
handset in the main
base to register.

is

3

Charge the handset
for 15-20 hours.

TCX860
Handset

Main Base

TCX860 Handset

+

Main Base

– 4 –

Using Your Expansion Handset

Now that your new handset is registered, it can perform all the same
functions as the handsets originally included with your phone. With
your new handset, you can

• Transfer calls or intercom between handsets and base

• Use two handsets as 2-way radios in DirectLink mode

• Use two handsets as a baby/room monitor

• Hold up to 5-way conference calls

• Access voice mail using handsets or main base

See the owner's manual that came with your main base unit for
complete instructions on operating your new expanded digital phone.

Battery Information

Low battery alert

When the batteries are very low and need to be charged, the phone is
programmed to eliminate functions in order to save power.

The batteries need to be charged when:

- The empty battery icon appears.

Low Battery

-

If the phone is in standby mode, none of the keys will operate.
If you are on a call, complete your conversation as quickly as possible,
and return the handset to the charging cradle.

Cleaning the battery charging contacts

To maintain a good charge, it is
important to clean the charging
contacts on the handset once a
month. Using water only, dampen a
cloth to clean the charging contacts.
Then make sure to go back over the
charging contacts with a dry cloth
before returning the handset to the charger to charge.

Caution: Do not use paint thinner, benzene, alcohol, or other chemical

products. Doing so may discolor the surface of the telephone and
damage the finish.

appears in the display.

– 5 –

I.C. Notice

TERMINAL EQUIPMENT

NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical

Specifications. This is confirmed by the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based on a Declaration of
Conformity indicating that Industry Canada technical specifications were met. It does not
imply that Industry Canada approved the equipment.

NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the
equipment itself. The REN assigned to each terminal equipment provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all the devices does not
exceed five.

RADIO EQUIPMENT

The term “IC:” before the radio certification number only signifies that Industry Canada
technical specifications were met.

Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device. “Privacy of communications may not be ensured
when using this telephone.”

As an Energy Star Partner, Uniden has determined that this product or product
models meets the Energy Star guidelines for energy efficiency.
Energy Star is a U.S. registered mark.

THE FCC WANTS YOU TO KNOW

Changes or modifications to this product not expressly approved by Uniden, or operation of
this product in any way other than as detailed by the owner's manual, could void your
authority to operate this product.

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
Privacy of communications, may not be ensured when using this phone.

To insure the safety of users, the FCC has established criteria for the amount of radio
frequency energy various products may produce depending on their intended usage. This
product has been tested and found to comply with the FCC’s exposure criteria. For body worn
operation, the FCC RF exposure guidelines were also met when used with the RadioShack
accessories supplied or designed for this product. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines and should be avoided.

Uniden works to reduce lead content in our PVC coated cords in our products and accessories.

Warn ing!

The cords on this product and/or accessories contain lead, a chemical known to the State of
California to cause birth defects or other reproductive harm. Wash hands after handling.

– 6 –

One Year Limited Warranty

Important: Evidence of original purchase is required for warranty service.

WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”)

ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to
be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.

WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12
months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not
maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits,
subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or
repaired by someone other than an authorized Uniden service center for a defect or malfunction covered
by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not
manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s
manual for this product.

STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while
this warranty is in effect, warrantor will either repair or replace the defective unit and return it to you
without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or
its representatives in connection with the performance of this warranty. Warrantor may replace the unit
with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE
WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY
NATURE WHATSOEVER, WHETHER EXPRESSED, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT
NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or
consequential damages so the above limitation or exclusion may not apply to you.

LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have

other rights which vary from state to state. This warranty is void outside the United States of America
and Canada.

PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the
owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its
original packaging). Disconnect the battery from the Product and separately secure the battery in its own
separate packaging within the shipping carton. The Product should include all parts and accessories
originally packaged with the Product. Include evidence of original purchase and a note describing the
defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable
means, to warrantor at:

[phone], 8 a.m. to 5 p.m. Central, Monday through Friday

Uniden America Corporation

Parts and Service Division

4700 Amon Carter Blvd.

Fort Worth, TX 76155

May be covered under one or more of the following U.S. patents:

4,523,058 4,595,795 4,797,916 5,381,460 5,426,690 5,434,905 5,491,745
5,493,605 5,533,010 5,574,727 5,581,598 5,650,790 5,660,269 5,661,780
5,663,981 5,671,248 5,696,471 5,717,312 5,732,355 5,754,407 5,758,289
5,768,345 5,787,356 5,794,152 5,801,466 5,825,161 5,864,619 5,893,034
5,912,968 5,915,227 5,929,598 5,930,720 5,960,358 5,987,330 6,044,281
6,070,082 6,125,277 6,253,088 6,314,278 6,418,209

– 7 –

FOR

ACCESSORIES,

GO ONLINE @

WWW.UNIDEN.COM

REGISTER ONLINE TODAY!

THANK YOU FOR BUYING A UNIDEN PRODUCT.

©2004 Uniden America Corporation, Fort Worth, Texas. Contains additional foreign articles. Custom manufactured in China.

UUZZ01854BZ