When using your telephone equipment, these basic safety precautions should always be followed to
reduce the risk of fire, electrical shock, and injury to persons:
Read and understand all instructions.
1.
Follow all warnings and instructions marked on the product.
2.
Unplug this product from the wall outlet before cleaning, and use a dry cloth, without liquid or aerosol
3.
cleaners.
4. Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.
Do not place this product on an unstable cart, stand, or table. The telephone may fall, causing
5.
serious damage to the unit.
Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect the
6.
product from overheating, these openings must not be blocked or covered. This product should
never be placed near or over a radiator or heat register. This product should not be placed in a
built-in installation unless proper ventilation is provided.
This product should be operated only from the type of power source indicated on the marking label.
7.
If you are not sure of the type of power supply to your home, consult your dealer or local power
company.
Do not allow anything to rest on the power cord. Do not locate this product where the cord will be
8.
damaged by persons walking on it.
Do not overload wall outlets and extension cords, as this can result in the risk of fire or electrical
9.
shock.
Never push objects of any kind into this product through cabinet slots, as they may touch dangerous
10.
voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of
any kind on the product.
11. To reduce the risk of electric shock, do not disassemble this product. Take it to qualified service
personnel when service or repair work is required. Opening or removing covers may expose you to
dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the
appliance is subsequently used.
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the
12.
following conditions:
A. When the power supply cord is damaged or frayed.
If liquid has been spilled into the product.
B.
If the product has been exposed to rain or water.
C.
If the product does not operate normally when following the operating instructions. (Adjust only
D.
those controls that are covered by the operating instructions. Improper adjustment of other
controls may result in damage and will often require extensive repair work by a qualified
technician.)
If the product has been dropped or the cabinet has been damaged.
E.
If the product exhibits a distinct change in performance.
F.
Do not use the telephone to report a gas leak in the vicinity of the leak.
13.
2XCI860
Battery Safety Precautions
Caution:
To reduce the risk of fire or injury to persons by the battery, read and follow these instructions:
1. Use only the appropriate type and size Battery Pack specified in this Operating Guide.
Do not dispose of the Battery Pack in a fire. The cell may explode. Check the Nickel-Cadmium
2.
Battery Disposal package insert for disposal instructions.
Do not open or mutilate the Battery Pack. Released electrolyte is corrosive and may cause damage
3.
to the eyes or skin. It may be toxic if swallowed.
Exercise care in handling the battery in order not to short the battery with conducting materials such
4.
as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.
Charge the Battery Pack provided with or identified for use with this product only in accordance with
5.
the instructions and limitations specified in the instruction manual provided for this product.
Observe proper polarity orientation between the Battery Pack and battery charger.
6.
SAVE THESE INSTRUCTIONS
XCI8603
Introduction
Congratulations on your purchase of the DXI860 telephone with an integrated digital answering system.
This phone is designed to exacting standards to provide reliability, long life, and outstanding performance.
Features
Voice Scramble
•
• 25 46/49 MHz Channels
• 30 Number Caller ID Memory
•
AutoSecure
•
Random Code
™
™ Digital Security
• Handset Ringer/Volume Controls
• UltraClear Plus
• Pulse/Tone Dialing
•
AutoTalk
•
AutoStandby
™
™
• 10-Number Memory
• 1-way Page/Find Button
• Redial/Flash Key
• 14 Day Battery Life
The Voice Scrambled DXI860 protects your
privacy by changing the RF signal between the
Handset and Base when you make or receive
calls. It’s difficult or impossible for someone to
receive and understand your calls.
AutoTalk™
removing the Handset from the Base so you don’t
have to waste time pushing buttons or flipping
switches.
simply returning the Handset to the Base.
allows you to answer a call by just
AutoStandby™
allows you hang up by
UltraClear Plus
The
together with 25 different channels, virtually
eliminates background noise and provides you
with the best possible reception during all of your
conversations.
To protect you against misbilled calls which might
result from your phone being activated by other
equipment,
automatically selects one of over 65 thousand
digital security codes for the Handset and Base
Units. Also, the
electronically locks your phone when the Handset
is in the Base.
To get the most from your phone, please read this
Operating Guide thoroughly. Also be sure to
complete the Product Registration form and mail it
in.
Be sure to visit our Internet site at:
http:\\www.uniden.com!
Random Code™
innovative technology,
digital security
AutoSecure
™ feature
4XCI860
Included with the DXI860
If any of these items are missing or damaged, contact Uniden Customer Service at: (800) 297-1023, 8:00
am to 5:00 p.m. Central, Monday through Friday.
Unplug all electrical appliances when you know an electrical storm is approaching. Lightning can pass
through your household wiring and damage any device connected to it. This phone is no exception.
Warning: Please do not attempt to unplug any appliance during an electrical storm.
Caution: Changes or modifications to this product not expressly approved by Uniden, or operation of this
product in any way other than as detailed by this Operating Guide, could void your authority to
operate this product.
Range
Your new phone is designed to achieve the maximum possible range by transmitting and receiving
according to the highest specifications set forth by the FCC. We have rated this phone to operate at a
maximum distance with the qualification that the range depends upon the environment in which the
telephone is used. Many factors limit range, and it would be impossible to include all the variables in our
rating. The Maximum Range rating of this phone is meant to be used as a means of comparison against
other range claims.
Telephone Line Problems
The FCC has granted the telephone company the right to disconnect service in the event that your
phone causes problems on the telephone line. Also, the telephone company may make changes in
facilities and services which may affect the operation of your unit. However, your telephone company
must give adequate notice in writing prior to such actions to allow you time for making necessary
arrangements to continue uninterrupted service.
XCI8605
If you are having trouble with your telephone service, you must first disconnect your phone to determine
if it is the cause of your problem. If you determine that it is the cause, you must leave it disconnected
until the trouble has been corrected.
Radio Interference
Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking
noises in the Base Unit. This interference is caused by external sources such as TV, refrigerator,
vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises
continue and are too distracting, please check around your home to see what appliances may be
causing the problem. In addition, we recommend that the Base not be plugged into a circuit that also
powers a major appliance because of the potential for interference. Be certain that the antenna on the
unit is fully extended when needed.
In the unlikely event that you consistently hear other voices or distracting transmissions on your phone,
you may be receiving radio signals from another cordless telephone or other source of interference. If
you cannot eliminate this type of interference, you need to change to a different channel.
Finally, it should be noted that some cordless telephones operate at frequencies that may cause
interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the
cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced,
moving the cordless telephone farther away from the TV or VCR will often reduce or eliminate the
interference.
More Than One Cordless Telephone
If you want to use more than one cordless telephone in your home, they must operate on different
channels. Press the channel key to select a channel that provides the clearest communication.
Cordless Telephone Privacy
Cordless telephones are radio devices. Communications between the handset and base of your cordless
telephone are accomplished by means of radio waves which are broadcast over the open airways.
Because of the inherent physical properties of radio waves, your communications can be received by
radio receiving devices other than your own cordless telephone unit. Consequently, any communications
using your cordless telephone may not be private.
6XCI860
Installation
Selecting a Location
Before choosing a location for your new phone, there are some important guidelines you should consider:
• The location should be close to both a phone jack and continuous power outlet.
Note: A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.
• Keep the Base Unit and Handset away from sources of electrical noise such as motors or
fluorescent lighting.
• Be sure there is sufficient space to fully extend the Base Unit antenna.
• The Base Unit can be placed on a desk or tabletop or mounted on a standard AT&T or GTE wall
plate.
• If you decide to mount your phone on the wall, make sure to change the handset retainer so that the
tab which holds the Handset faces up. (See page 11 for more information.)
• You should charge your new phone for 15-20 hours before completing the installation or using the
Handset.
Telephone Line Outlets
There are two types of phone outlets:
Modular Jack
Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic
connector which plugs into this type of jack. If you do not have modular phone jacks, contact your local
telephone company for information about their installation.
Hard-wired Jack
Some equipment is wired directly to a phone jack, and these types of installations require a modular jack
converter. This type of installation is not difficult; however, you should contact your Uniden telephone
dealer or a telephone supply store for advice about the proper adapter or converter for your particular
situation.
Connecting the Telephone Cords
Consider these safety guidelines before connecting the telephone cords:
Caution!
•
Never install telephone wiring during a lightning storm.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected.
•
Use caution when installing or modifying telephone lines.
XCI8607
Applying Power to the Base Unit
The DXI860 phones require an AC outlet, without a switch to interrupt power, and the included AC
adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, connect the
adapter as shown below.
Wrap the power cord around the convenient notch on the bottom.
Important: Place the power cord so that it does not create a trip hazard, or where it could become
chafed and create a fire or other electrical hazards.
Adapter Safety Feature
The AC adapter furnished with this phone may be equipped with a polarized line plug — a plug having
one blade wider than the other. This plug will fit into the power outlet only one way. If you are unable to
insert the plug fully into the outlet, try reversing the plug.
• Do not alter the shape of the blades of the polarized plug.
• If you cannot plug the AC adapter into the outlet, contact somenone about replacing the outlet.
8XCI860
Desk or Tabletop Installation
1. Place the Base on
a desk or tabletop.
2. Plug the AC
Adapter cord into
the 9V DC input
jack on the Base
Unit.
5. Plug the other end
of the cord into the
telephone jack on
the wall.
6. Plug the AC
Adapter into a
standard 120V AC
wall outlet.
Note: Do not use
an outlet controlled
by a wall switch.
Wall Installation
3. Place the AC
Adapter cord
around the strain
relief.
4. Plug one end of the
long telephone cord
into the
jack on the Base
Unit.
TEL LINE
Standard Wall Plate Mounting
These phones are designed to be mounted on a
standard AT&T or GTE wall plate.
1. Plug the AC
Adapter into the
Base Unit.
2. Place the AC
Adapter cord inside
the molded channel.
XCI8609
3. Plug one end of the
short telephone
cord into the
TEL LINE
jack on the
Base Unit.
4. Place the
telephone cord
inside the molded
channel on the
bottom of the Base
Unit.
Then plug the other
end of the
telephone cord into
the modular jack on
the wall.
5. Place the Base Unit
on the posts of the
wall plate and push
down until it’s firmly
seated.
Direct Wall Mounting
If you do not have a standard wall plate, you can
mount your phone directly on a wall. Before
mounting your phone, consider the following:
• Select a location away from electrical cables,
pipes, or other items behind the mounting
location that could cause a hazard when
inserting screws into the wall.
• Make sure the wall material is capable of
supporting the weight of the Base Unit and
Handset.
• Use #10 screws with anchoring devices
suitable for the wall material where the Base
Unit will be placed.
1. Insert two mounting
screws 3
apart. Allow about
3
⁄
16
between the wall
and screw heads
for mounting the
phone.
15
⁄
16
of an inch
inches
6. Plug the AC
Adapter into a
standard 120V AC
wall outlet.
Note: Do not use
an outlet controlled
by a wall switch.
2. Plug the AC
Adapter into the
Base Unit.
3. Place the AC
Adapter cord inside
the molded channel.
10XCI860
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.