Uniden DECT1820 User Manual

DECT1820

EXTRA HANDSET

OWNER'S

MANUAL

OWNER'S MANUAL

Welcome

Congratulations on your purchase of the Uniden DECT1820
optional handset and charger. This expansion handset is
compatible with models in the following series: DECT1825,
DECT1825+1, DECT1855 and DECT1855+1
(Model numbers may vary.)
Each model within this series will support up to six handsets. You
can place a fully featured cordless handset anywhere in your home
as long as AC power is available to connect the handset's charging
cradle.

IMPORTANT

The DECT1820 expansion handset will not operate unless it has
been registered to your main base. Refer to the owner's manual
supplied with your main base model for detailed instructions on
operating your new expansion handset.

Checking the Package Contents

Make sure you have received the following items in the package.
If any of these items are missing or damaged, contact
your retailer.

• Cordless Handset

• Charging Cradle

• AC Adapter
(INPUT:240V AC 50Hz)
(OUTPUT:6V DC 200 mA)

• 2 x AAA size Rechargeable Batteries (1.2V 650mAh)

• This Owner ’s Manual

• Other Printed Material

[1]

Installing Your Expansion Handset

Follow these three easy steps to get your new handset ready to
use:

1

Connect the charger.

2

Install the batteries and charge your new handset for 15-20
hours.

Register your new handset to the main base.

3

Step 1:Connect the Charger

1

Connect the AC adapter to the
jack and to a standard 240V AC wall
outlet.

2

Set the charger on a desk or tabletop.

Use only the supplied AC

•

adapter. Do not use other
AC adapter.

• Place the charger close to the AC outlet so that you can
unplug the AC adapter easily.

[2]

DC IN

Step 2:Install the Batteries and charge your new
handset for 15-20 hours

12Remove the battery compartment cover. Press down on the

semi-circle indent and slide the cover off.

Charge the battery for 15-20 hours before using. To charge the
batteries, place the handset on the charger.
While charging, the symbol scrolls and when the battery is fully
charged, all the bars of the battery symbol will be filled when the
phone is off the cradle.

If the symbol does not appear, reposition the handset in the
charger, ensuring that the charging points contact.

•Use only the Uniden batteries supplied with your phone.

•Recharge your handset on a regular basis by returning

the handset to the charger after each phone call.

Step 3:Register the Handset

YOU NEED TO REGISTER THE DECT1820 TO THE MAIN BASE
BEFORE USE!

For Main Base Models DECT1825, DECT1825+1, DECT1855 and
DECT1855+1, When you register a new handset to your base, you
will be asked to enter the base PIN code.

The pre-set PIN code is 0000. If you wish you can change this
code, see owner's manual for detailed instruction.

Before registering, make sure that you have the base and handset
in front of you. Also, make sure all handsets and the base are in
standby mode.

[3]