Uniden Dect 1705 User Manual

DECT 1705

Accessory Handset

For more exciting new products please visit our website:

Australia: www.uniden.com.au

1

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:

• This unit is NOT waterproof. DO NOT expose this unit to moisture.

• DO NOT expose this unit to rain.

• Do not use this product near water, for example, near a bath tub,

wash bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.

• Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock from
lightning.

• Do not use the telephone to report a gas leak in the vicinity of the leak.

SAVE THESE INSTRUCTIONS!

General Notices for New Zealand Model:

• The grant of a NZ Telepermit for any item of terminal equipment
indicates only that Telecom has accepted that the item complies with
minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort
of warranty. Above all, it provides no assurance that any item will work
correctlyin all respects with another item of Telepermitted equipment
of a differentmake or model, nor does it imply that any product is
compatiblewith all of Telecom’s network services.

• The maximum volume setting of this telephone exceeds the Telecom
specified volume requirement. Telecom takes no responsibility for the
high volume available on this telephone, who believe this telephone is
too loud should contact the manufacturer at the website indicated on
owner’s manual warranty page.

• For telephone networks other than Telecom there may be a charge
incurred for local calls if the Insert 0 feature is on. Turn Inser t 0 off.

• This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.

2

What’s in the Box?

DECT 1705

Rechargeable Battery
Pack

Battery Cover

DECT 1705 accessory

AC adaptor

handset with charger

If any items are missing or damaged, contact your place of purchase
immediately. Never use damaged products!

Need help? Get answers at our website:

• www.uniden.com.au for Australian model

3

INSTALLING YOUR HANDSET

Charge the Battery

1. Unpack the handset, battery pack,

and batter y cover. If you need to
remove the cover, press in on the
notch and slide the cover down and
off.

2. Line up the battery connector with the

jack inside the handset; the connector
only fits one way.

3. Push the connector in until it clicks

into place; tug gently on the wires
to make sure the battery is securely
connected.

4. Replace the battery cover and slide it into place.

5. Use the AC adaptor to connect the power jack on the charger to a

regular indoor (240V AC) power outlet.

6. Place the handset in the charger with the display facing forward. If the

display doesn’t light up, reseat the handset or connect the charger to
a different outlet.

#Charge the handset completely (about 15 hours) before using it.

4

REGISTERING TO A BASE

The accessory handset won’t work until you register it to a
compatible Uniden cordless phone!

Compatible Bases

This handset is designed for use with Uniden’s DECT 1715 and DECT
1735 bases.

Registration Methods

This handset is designed for use with DECT 1715 and DECT 1735 bases.
For the most up-to-date list of compatible bases with this handset, see
our website.

Does the handset fit in the base cradle?

Yes Place the handset in the base. The display should say

No Does the base have an LCD display?

#After about 30 seconds, the handset display should say

Registration Complete.

Test the Connection

Pick up the handset and press TALK /F L ASH. Make sure you get a dial
tone. (Press END to hang up.)

If.. Try..

x you don’t hear a dial tone the

display says Registration Failed

Registering.

No

On the base, press and hold FIND HS when the
phone is in standby (about 5 seconds).
On the handset, press and hold #DND until the
handset display says Registering (about 2
seconds).

x Making sure the handset is fully

charged, before trying again.

5

IMPORTANT INFORMATION

1. All features and operation for the handset are described in the owner’s

manual for the base.

2. Owner’s Manual for all Uniden phones are available on our website for

free downloading.

AC Adaptor

Parts Number Input Voltage Output Voltage

AAD-600S(R) or
AAD-600S(M)

Battery Information

Type Capacity Talk time Standby Time

BT-694 or
BT- 694s
BT- 6 9 4n

•Use only the supplied AC adaptors.

•Use the proper adaptor for the base and any chargers.

•Do not place the unit in direct sunlight or subject it to high

temperatures.

•Replace the battery when the talk or standby time becomes

noticeably reduced. For replacements, visit the online shop on our
website (see the front cover).

•When the battery gets low, the handset beeps and shows a low

battery alert; put the handset in the cradle for recharging.

100-240V AC, 50/60Hz 9V DC @ 210mA

650mAh or 500mAh
or 400mAh

about 10 hours about 7 days

6

ONEYEAR LIMITED WARRANTY

DECT 1705
Important:

Satisfactory evidence of the original purchase is required for warranty
service. Please refer to our Uniden website for any details or warranty
durations offered in addition to those contained below.

Warrantor:

The warrantor is Uniden Australia Pty Limited ABN 58 001 865 498
(“Uniden Aust”).

Terms of Warranty: Uniden Aust warrants to the original retail
purchaser only that the DECT 1705 (“the Product”), will be free from
defects in materials and craftsmanship for the duration of the warranty
period, subject to the limitations and exclusions set out below.

Warranty Period: This warranty to the original retail purchaser is only
valid in the original country of purchase for a Product first purchased
either in Australia or New Zealand and will expire one (1) year from the
date of the original retail sale. If a warranty claim is made, this warranty
will not apply if the Product is found by Uniden to be:

A. Damage d or not maintained in a rea sonable manner or as re commended

in the relevant Uniden Owner’s Manual;

B. Modified, altered or used as part of any conversion kits, subassemblies

or any configurations not sold by Uniden Aust;

C. Improperly installed contrary to instructions contained in the relevant

Owner’s Manual

D. Repaired by someone other than an authorized Uniden Repair Agent in

relation to a defect or malfunction covered by this warranty; or

E. Used in conjunction with any equipment, parts or a system

notmanufactured by Uniden.

Parts Covered: This warranty covers the Product and included
accessories.

User-generated Data: This warranty does not cover any claimed loss of
or damage to user-generated data (including but without limitation phone
numbers, addresses and images)that may be stored on your Product.

7

Statement of Remedy: If the Product is found not to conform to this
warranty as stated above, the Warrantor, at its discretion, will either
repair the defect or replace the Product without any charge for parts or
service. This warranty does not include any reimbursement or payment
of any consequential damages claimed to arise from a Product’s failure to
comply with the warranty. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are entitled to a
replace ment or refund for a major f ailure and for compe nsation for any other
reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure. This warranty is in addition
to and sits alongside your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER GUARANTEES
ACT (New Zealand) as the case may be, none of which can be excluded.

Procedure for Obtaining Warranty Service: Depending on the country
in which the Product was first purchased, if you believe that your Product
does not conform with this warranty, you should deliver the Product,
together with satisfactory evidence of your original purchase (such as a
legible copy of the sales docket) to Uniden. Please refer to the Uniden
website for address details. You should contact Uniden regarding
any compensation that may be payable for your expenses incurred in
making a warranty claim. Prior to delivery, we recommend that you make
a backup copy of any phone numbers, images or other data stored on
your Product, in case it is lost or damaged during warranty service.

UNIDEN AUSTRALIA PTY LTD

Phone number: 1300 366 895
Email: [e-mail]

2016 Uniden Australia Pty Ltd

c

Printed in Vietnam U01UU282BZZ(0)

U01UU911BZZ(0)