Uniden DCX 700 User Manual
DCX 700
Accessory Handset
OWNER'S
MANUAL
UU869BH_TCX700 OM.fm Page 2 Wednesday, June 2, 2004 10:46 AM
Welcome
Congratulations on your purchase of the Uniden DCX700 optional handset
and charger. This expansion handset is for use with the Digital Spread
Spectrum series: DCT746, DCT748, and DCT7488 (model numbers may
vary). Each model within this series will support up to four handsets. You
can place a fully featured cordless handset anywhere in your home as long
as you have AC power is available to connect the handset charging cradle.
IMPORTANT
The DCX700 expansion handset will not operate unless it has been
registered to your main base. This manual describes how to set up and
connect your new handset; for instructions on operating your new
handset, refer to the owner's manual supplied with your main base.
To purchase expansion handsets (DCX700), visit our web site at
www.uniden.com.
Backward / Forward Compatibility
Your phone may be compatible with other Uniden 2.4 GHz Digital
Expandable Systems. Please visit our website @ www.uniden.com
<http://www.uniden.com>.
Checking the Package Contents
Make sure you have received the following items in the package.
If any of these items are missing or damaged, contact the Uniden Parts
Department.
•Cordless Handset
•Charging Cradle
• Battery Pack (BT-446)
(Capacity: 800 mAH, 3.6V)
• AC Adapter (AD-0005)
(INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA)
•Beltclip
• This Owner’s Manual
• Other Printed Material
Uniden Parts Department at (800) 554-3988
Hours: M-F 8:00 a.m. to 5:00 p.m. CST.
or visit our website at
www.uniden.com
– 2 –
UU869BH_TCX700 OM.fm Page 3 Wednesday, June 2, 2004 10:46 AM
Installing Your Expansion Handset
Follow these three easy steps before using your new cordless handset.
Install the battery pack.
1
Connect the charger and charge your new handset for 15-20 hours.
2
Register your new handset to the main base.
3
Step 1: Install the Battery Pack
Press down on the handset battery
1
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
Plug the battery pack connector
2
(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment, and
push the connector in until you hear a
click.
Make sure you have a good connection
3
by slightly pulling on the battery
wires. If the connection is secure, the
battery jack will remain in place.
Place the battery case cover back on
4
the handset by sliding it upwards
until it clicks into place.
Place the handset in the charging
5
cradle with the keypad facing forward.
• Use only the Uniden battery
(BT-446) supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department. (See
page 2.)
• Recharge your handset on a regular basis
by returning the handset to the charger
after each phone call.
Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly
– 3 –
Loading...