Uniden BW2101 Owner's Manual
BW2101
3.5” LCD Portable Wireless
Baby Monitoring System
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz
To avoid any risk of electric shock from lightning, avoid handling any electronic
This manual contains important information about this product’s
Important Safety Precautions
operation. If you are installing this product for others, leave this manual
or a copy with the end user.
When using your equipment, always follow basic safety precautions to reduce
the risk of fire, electric shock and injury to persons, including the following:
This equipment is NOT waterproof. DO NOT expose it to rain or moisture.
•
DO NOT immerse any part of the product in water. Do not use this product
•
near water, e.g., near a bath tub, wash bowl, kitchen sink or laundry tub, in a
wet basement or near a swimming pool.
•
devices (except battery powered ones) during an electrical storm.
Use only the power cord and/or batteries indicated in this manual. Never
•
dispose of any batteries in a fire: they may explode. Check with local codes
for possible special disposal instructions.
Never tug or pull on any power cord: be sure to leave some slack in the cord
•
when placing your equipment, and always use the plug to unplug the cord
from the wall outlet.
Never leave power cords where they can become crushed, cut, or frayed;
•
when running power cords, avoid letting them rub against any sharp edges or
lie across any high traffic areas where people might trip over them.
Do not use the device if the adaptor cords or plugs have been damaged, the
•
unit has been exposed to liquids, or the unit has been dropped or is damaged.
2
Important Safety Precautions (cont’d)
Warnings to Parents and Other Users
Failure to follow these warnings and the assembly instructions could result in
serious injury or death. This product is not designed or intended for use as a
medical monitor, nor should this product be used as a substitution for medial
supervision. Always be sure that both the transmitter (camera) and receiver
(monitor) are working properly and are within range of each other.
•
STRANGULATION HAZARD. Keep the adaptor cords out of the reach of
children.
•
WARNING: KEEP OUT OF THE REACH OF CHILDREN.
•
Allow for proper ventilation when units are in use. Do not cover the camera or
monitor with any object such as a blanket. Do not place it in a drawer or in
any location which would muffle the sound or interfere with the normal flow
of air.
For best results:
To avoid damage to your equipment, follow these simple precautions:
•
Do not drop, puncture or disassemble any part of the equipment. There are
no user-serviceable parts inside.
Do not expose the equipment to high temperatures, and avoid leaving the
•
equipment in direct sunlight for more than a few minutes. Heat can damage
the case or electrical parts.
Do not place heavy items on top of the equipment or expose the equipment
•
to heavy pressure.
Remove the power adaptor during long periods between usages.
•
Clean only with a dry cloth.
Failure to follow the instructions in this operating manual will void the warranty.
Uniden assumes no liability for damages to property or injury to persons
caused by improper handling or failure to comply with these safety instructions.
3
Contents
Important Safety Precautions ..................................................................
What’s in the Box? ....................................................................................
2
4
Parts of the BW2101 Baby Monitoring System ......................................
Getting Started ..........................................................................................
STEP 1. Set-up and Installation .............................................................
STEP 2. Basic Operation ........................................................................
I. Get to Know the Camera ..................................................................
II. Get to Know the LCD Monitor ..........................................................
STEP 3. Advanced Operation ................................................................
I. Get to Know the Display Icons ........................................................
II. Get to Know the Main Menu ...........................................................
System Setup - Time Setting / Factory Default ...............................
Camera Setup - Turn Camera(s) On/Off / Camera Scan Period.....
Pairing a Camera / Power Save Mode / SD Card Format ..............
VOX Setting - VOX Sensitivity / Enable VOX Recording.................
Brightness........................................................................................
Alarm Setup / Event List .................................................................
About Digital Wireless Technology ........................................................
5
7
8
9
9
9
10
10
11
11
12
13
14
14
15
16
Troubleshooting .......................................................................................
Product Specifications ............................................................................
Storage Media Management ...........................................................
Warranty ...................................................................................................
What’s in the Box?
1 x Digital Wireless Camera
1 x 3.5” LCD Digital Wireless Monitor
1 x AC Adaptor for Camera
1 x AC Adaptor for Monitor
1 x Goose Neck Camera Stand with mount screws
1 x Owner’s Manual
NOTE! If any items are missing or damaged, contact your
place of purchase immediately. Never use damaged products!
17
18
18
18
4
Camera
Parts of the BW2101 Baby Monitoring System
13
PWR.
1. Lens
2. IR (Infra Red) LEDs
3. EDS (sensor)
4. Battery Indicator
5. Link Indicator
6. Power Indicator
7. Microphone
LCD Monitor (Receiver)
DC IN 5V/1A
8. Power / Lullaby play switch
9. Pairing Key
10. Reset
11. DC IN Jack
12. Power Adaptor
13. Goose Neck Mount Stand
BSU
1. Battery Indicator
2. Power Indicator
3. Cursor up / Channel switch
4. Cursor left / Volume down
5. Cursor down / Lullaby play button
6. Cursor right / Volume up
7. Enter / Exit Menu button
8. Record / Delete
9. PTT (Push to Talk) / OK Confirm
10. Power button
11. SD card slot
12. USB port
13. DC IN jack
14. Reset
15. Power adaptor
5
Step 1.
Getting Started
battery when the battery indicator lights
Connection & Installation
Camera Connection
2
DC IN 5V/1A
1. Connect the power cable to the
camera’s DC IN jack and then plug
the power adaptor to a 240VAC wall
outlet.
2. Slide the power switch down once to
turn ON the camera.
NOTE! The built-in Lithium battery
charges automatically when the power
1
adaptor is connected. Charge the
battery to full capacity before using the
monitor in portable mode. The battery
is at full capacity when the green
(battery indicator) turns off.
NOTE! Only use the 5V/1A power
adaptor provided in the package.
LCD Monitor Connection
2
1
1. Connect the power cable to the
monitor’s DC IN jack and then plug
the power adaptor to a 240VAC wall
outlet.
2. Press the power button to turn ON
the monitor.
NOTE! The built-in Lithium battery
charges automatically when the power
adaptor is connected. Charge the
battery to full capacity before using the
monitor in portable mode.
NOTE! In portable mode, charge the
up red.
NOTE! Only use the 5V/1A power
adaptor provided in the package.
6
Loading...