UNICOM SmartPoE/802M, SmartPoE/802M POE-63208T Specifications

SmartPOE/802M

8 Port 10/100 Managed PoE Switch
with 2 Gigabit Combo

Features

• System Interface/Performance

– RJ-45 por t suppor t Auto MDI/MDI-X Function
– Embedded 8-por t PoE inject function
– Store-and-Forward Switching Architecture

Back-plane (Switching Fabric): 5.6Gbps

–
– 1Mbits Packet Buffer
– v8K MAC AddressTable

• Spanning Tree

– Supports IEEE802.1d Spanning Tree
– Supports IEEE802.1w Rapid Spanning Tree

• VLAN

– Port Based VLAN
– Supports 802.1 Q TagVLAN
– GVRP

• X-ring

– X-ring, Dual Homing, and Couple Ring Topology
– Provides redundant backup feature and the recovery time

below 300ms

• Port Trunk with LACP

• QoS (Quality of Service)

– Support IEEE 802.1p Class of Service,
– Per port provides 4 priority queues
– Port Base,Tag Base and Type of Service Priority

• Bandwidth Control

– Ingress Packet Filter and Egress Rate Limit
– Broadcast/Multicast Packet Filter Control

• Port Mirror: Monitor traffic in switched networks

– TX Packet only, RX Packet only, Both of TX and RX Packet

• System Event Log

– System Log Ser ver/Client
– SMTP e-mail Alert

• Security

– Port Security : MAC address entries/filter
– IP Security : IP address security management to prevent

unauthorized intruder.

– Login Security: IEEE802.1X/RADIUS

• SNMP Trap

– Device cold star t, Authentication failure, X-ring topology

changed, Port Link up/Link down, PoE port events

• IGMP with Quer y mode for Multi Media Application

• TFTP Firmware Update and System Configure Restore

and Backup

Feeds PoE to up to Eight devices!

8 Port 10/100 Managed PoE

Switch with 2 Gigabit Combo

POE-63208T

802.3af

Compliant

PART NUMBER DESCRIPTION

POE-63208T 8 Port 10/100 Managed PoE

Switch with 2 Gigabit Combo

The Smar tPoE/802M is a multi-port switch that can be used to build
high-performance switched workgroup networks.This switch is a store­and-forward device that offers low latency for high-speed networking
and features a “store-and-forward “switching scheme.This allows the
switch to auto-learn and store source addresses in an 8K-entr y MAC
address table. The Smar tPoE/802M is targeted at workgroup,
department or backbone computing environments. The SmartPoE/802M
has eight auto-sensing 10/100Base-TX RJ-45 ports and all ports support
the PoE injector function.The switch as two auto-detected Gigabit
Combo por ts for higher connection speed.

SEE BACK FOR FULL SPECIFICATIONS

121807 Printed in U.S.A. UNILT121107

908 Canada Court

City of Industry, CA 91748 U.S.A.
Phone: [phone] or 800.346.6668 Fax: [phone]
www.unicomlink.com e-mail: [e-mail]

©UNICOM 2007. UNICOM is a trademark of UNICOM Electric, Inc. All rights reserved.

Specifications subject to change without notice.

SPECIFICATIONS

Standards: IEEE 802.3 10Base-T Ethernet

IEEE 802.3u 100Base-TX
IEEE802.3ab 1000Base-T
IEEE802.3z Gigabit fiber
IEEE802.3x Flow Control and Back Pressure
IEEE802.3ad Port trunk with LACP
IEEE802.3af Power over Ethernet
Cisco Legacy PD
IEEE802.1d Spanning Tree/
IEEE802.1w Rapid Spanning Tree
IEEE802.1p Class of Service
IEEE802.1Q VLAN Tag
IEEE 802.1x User Authentication (Radius)

Connector 100Base-T: 8x RJ-45 with auto MDI/MDI-X.

Ports 1~8 support POE inject function.

Packet throughput ability (Full-Duplex): 8.3Mpps @64bytes
Switch Architecture: Back-plane (Switching Fabric): 5.6Gbps
MAC address: 8K MAC address table with Auto learning function
Packet Buffer: 1Mbit
Flash ROM: 4Mbytes
DRAM: 32Mbytes
LEDs: System: Power (Green)

10/100TX Port: Link/Activity (Green), 100Mbps (Green),

Forwarding /Detect (Green).
Gigabit copper port: 1000/100Mbps (Green),
Link/Activity (Green)

Mini GBIC: Link/Activity (Green)
PoE: PWR FWD (Green)

Connectors: 2 x RJ-45 + 2 x 100/1000 SFP socket

POE pin assignment: RJ-45 ports #1 ~#8 support IEEE

802.3af End-point, Alternative B mode.

Per port feeding power: 20 Watts (maximum)

Positive (VCC+): RJ-45 pin 4, 5.
Negative (VCC-): RJ-45 pin 7, 8.
Data (1,2,3,6)

Power Supply: AC 100 ~240V, 200 Watts (Max)
Redundant Power Supply: 48V DC
Power Consumption: 135 Watts (open issue)
Ventilation: One DC Fan with fail detect function
Operating environment: 0˚~45˚, 5%~95% RH
Storage environment: -40˚~70˚, 95% RH
Dimension: 270mm (W) x 210mm (D) x 44mm (H)
EMI: FCC Class A, CE
Safety: UL, cUL, CE/EN60950-1

Spanning Tree: Supports IEEE802.1d Spanning Tree and IEEE802.1w

Rapid Spanning Tree

X-ring: Supports X-ring, Dual Homing, and Couple Ring

Provides redundant backup features and recovery time
below 300ms

Quality of Service: The quality of service determined by port, Tag and IPv4

Type of service, IPv4/ IPv6Different Service

Class of Service: Supports IEEE802.1p class of service, per port provides 4

priority queues

IP Security: Supports up to 10 IP addresses permission to access the

switch management and prevent unauthorized access.

Login Security: Supports IEEE802.1X Authentication/RADIUS
Flow Control: Supports Flow Control for Full-duplex and Back Pressure

for Half-duplex

IGMP: Supports IGMP snooping v1,v2

256 multicast groups and IGMP query

Port Security: Supports 100 entries of MAC address for static MAC and

another 100 for MAC filter

Port Mirror: Supports 3 mirroring types: “RX, TX, and Both packets”
Bandwidth Control: Supports ingress packet filter and egress packet limit

The egress rate control supports all of packet types with
limit rates of 100K~250Mbps

Ingress filter packet type combination rules are
Broadcast/Multicast/Unknown Unicast packet,
Broadcast/Multicast packet, Broadcast packet only and
all of packet. The packet filter rate can be set from 100k
to 250Mbps

DHCP: Provides DHCP Client/ DHCP Server/ IP Relay functions
DNS: Provides DNS client feature and supports Primary and

Secondary DNS servers.

SNTP: Supports SNTP to synchronize system clock via Internet
System log: Supports System log record and remote system log server
SMTP: Supports SMTP Server and 6 e-mail accounts for

receiving event alert

Power testing: Features power supply testing function
Configuration upload

and download: Supports text format configuration file for easy system

installation

SOFTWARE FEATURES

Management: SNMP v1 v2c, v3/ Web/Telnet/CLI
SNMP MIB: RFC 1215 Trap, RFC1213 MIBII, RFC 1157 SNMP MIB,

RFC standard: Port Based VLAN

SNMP Trap 1. Device cold start

Firmware Update Supports TFTP firmware update, TFTP backup

Port Trunk: LACP Port Trunk: 4 Trunk groups/Maximum 4 trunk

RFC 1493 Bridge MIB, RFC 2674 VLAN MIB, RFC 1643,
RFC 1757, RSTP MIB, Private MIB, PoE MIB

IEEE 802.1Q Tag VLAN (256 entries)/ VLAN ID (Up to
4K, VLAN ID can be assigned from 1 to 4096.)
GVRP (256 Groups)

2. Authentication failure

3. X-ring topology changed

4. Port Link up/Link down

5. DC disconnect trap-PoE port Event

and restore.

members