Unicol NEC W82, W82 User Manual

Wall Mount for NEC LCD8205

Flat . Tilting . Landscape . Portrait

Installation Instructions

INSPECT THE UNIT BEFORE INSTALLING

WARNING: Watch for pinch points. Do not put your fingers between movable parts.

1. Carefully inspect mount for shipping damage. If any damage is apparent, call your carrier claims agent and do not continue
the installation until the carrier has reveiwed the damage.

NOTE: Read all instructions before starting the installation.

2. Lay out components to ensure you have the required parts before proceeding (See Parts List below).

CAUTION: To prevent damage to the mount, study all instructions and illustrations before you begin the insatallation. Failure to
do so could render the Warranty for the mount and the equipment that attaches to it null and void. Pay particular attention to the
“Warnings” displayed in these instructions.

The structure to which the mount is anchored must be capable of supporting five times the total weight of the mount and all
attached equipment. We recommend installation by a Qualified AV Tradesperson, using masonry plugs or other reliable fixings to
ensure safe installation. Consult your builder or architect if in doubt.

If you have any questions regarding the installation, please contact UNICOL:

Europe: [phone]. [e-mail] UK: [phone] [e-mail]

Parts List:

Qty 2 Wall Plates (A)
Qty 2 Screen Arms (B)
Qty 2 Shoulder Bolts (C)
Qty 6 x M8 x 25mm screen fixing screws
(Screws to fix mount to wall are not included)

INSTALLING WALL PLATES (A)

NOTE: Both Landscape and Portrait versions are installed in the same manner.

WARNING: Improper installation can result in serious personal injury. Make sure that the structure can support a redundant

weight factor five times the total weight of the equipment: if not, reinforce the structure before installing the mounts.

1. Determine the exact mounting location on the wall prior to installation. Consider where the cables are routed from in relation
to the wall plates.

2. Screens can be mounted in Landscape or Portrait. Using the illustrations overleaf as a guide mark, drill and plug the wall
utilising all plate fixing holes. Ensure both Wall Plates are level and the plate marked with ‘L’ in on the left and plate marked ‘R’ is

on the right as viewed facing the wall.

Wall Plates are shown in relation to screen.

(B) (B)

(A) (A)

(C)
(C)

Wall Plate Fixing Locations

INSTALLING SCREEN ARMS (B)

1. Fix the Screen Arms (B) to the screen using the M8 fixing screws provided.
In Landscape mode use the 4 outer fixing points on the screen. In Portrait
mode use the 6 upper fixing points on the screen.

INSTALLING SCREEN ARMS (B) ONTO WALL PLATES (A)

WARNING: This screen is heavy - 145Kg. It may take a number of personnel to lift this or the use of a hoist.

1. Fix the Screen Arms (B) to the Wall Plates (A) by locating the hooks on the Screen Arms onto the top lugs of the
Wall Plates. The screen angle can then be set at either 0, 5 or 10 degrees by fixing the Shoulder Bolts (C) to the Wall
Plates, inserting them through the relevant holes in the Screen Arms.

If you have any questions regarding these Instructions please contact UNICOL

Europe: [phone]. [e-mail] UK: [phone] [e-mail]

11

1200

142.50

140

142.50

625

363

70

125

35

140

195.20 661.75

142.50

125

35

625

800

140

142.50

70

168.50

140

713.75

11

647.20

Landscape Portrait

L R L

R

(B) (A) (C)