Unibor BD35 Operator's Instruction Manual
Magnetic Base Drilling Machine
BD35
Operators Instruction Manual
And Spare Parts Listings
Index
Chapter 1. Technical Overview.
Chapter 2. Warnings and Safety Instructions.
Chapter 3. Operating Instructions.
Chapter 4. Maintenance Instructions.
Chapter 5. Exploded views and Spares lists.
Drill break down and Parts list
Electric motor break down
Introduction
Congratulations on the purchase of your new, lightweight multi-purpose
magnetic base drill. This is a high quality product with unique features that
make it the perfect solution for your entire hole drilling requirements.
! Easy to use and rugged design makes the BD35 a cost effective
solution to drilling clean, accurately positioned holes in your work
piece.
! Powered by a BLACK AND DECKER BD1321 MOTOR
2
Chapter 1. Technical Overview.
Machine BD35
Clamping force (Kg) 400
Speed (RPM) 450
Size (LxWxH) (mm) 300x100x390
Cutter Capacity (mm) 12 - 32
Twist Drill Capacity (mm) 13
Power Consumption (Watts) 700
Weight (Kg) 10
3
Chapter 2. Warnings and Safety Instructions.
Read these instructions carefully before operating, maintaining or servicing this tool.
Please keep these instructions in a safe accessible place.
Read to fully understand and
observe the following safety
precautions and warnings.
Careless or improper use of this
equipment may result in serious or
fatal injury.
WARNING!
Indicates instant possibility of
Operator Safety
severe personal injury or loss of
life, if instructions are not
! Always read the instructions carefully so as
followed.
to avoid any injury or damage when
unfamiliar with this equipment.
! Always wear a safety face shield or goggles.
! Wear ear defenders when using this
equipment.
! Always wear heavy clothing, boots and
gloves. Do not wear loose clothing, short
pants, sandals etc. and ensure that long hair is
tied up above shoulder length.
! Do not operate this equipment when tired, ill
or under the influence of alcohol, drugs or
medication.
! Never allow an inexperienced person operate
this equipment.
! Never operate the equipment in damp, or
water logged area.
! Keep all carrying handles and levers free
from oil.
Always wear eye, head and ear
protection equipment, when
using this tool
CAUTION!
Indications a possibility of
Tool Safety
personal injury or equipment
damage, if instructions are not
! Inspect the entire piece of equipment
followed.
before use.
! Replace damaged components, lubricate
where necessary and ensure that all
fasteners are secure.
! Always use a safety chain to secure the
equipment when it is being used above the
ground.
! Use only accessories that have been
recommended by the manufacturer. Failure
to do so could result in damage to the tool
and may invalidate the warranty.
WARNING!
Never modify the tooling any way. Do not use
your equipment for any job other than for
which it is intended.
! Keep hands away from the cutter when it is
rotating. Ensure that it has stopped rotating
and is disconnected from the power source
before touching the cutter.
Maintenance safety
! Maintain according to the manufacturers
recommended procedures.
! Disconnect the equipment from the power
source before attempting any maintenance.
! Use only genuine replacement components
4
! Do not attempt to gain access into the
electrical panel. There is risk of electrical
shock.
! Never use a larger diameter cutter than
specified for use with this equipment.
! Do not attempt to connect the equipment to a
power source other than that specified by the
manufacturer.
! Ensure that the cutter being used is sharp and
free from damage.
as recommended by the manufacturer.
Transport and Storage
! Before moving the tool, ensure that the
cutter has stopped rotating.
! Carry the tool with the cutter pointing away
from the body to avoid laceration.
! After use, clean the equipment and it’s
accessories and store in a dry place.
! Store the equipment along with the
maintenance tools in its correct carrying
case when not in use.
5
Loading...