Uncle Milton Torch In My Room User Manual

Batteries are not included.
Requires 2 x 1.5V AA/LR6 batteries.

x2

AA/LR6

TORCH

5+

2085

IN MY ROOM

Light-up Explorer’s Torch

How to install batteries

1. Gently press down on ame and turn counter
clockwise to detach ame from handle.

2. Insert 2 AA/LR6 batteries (not included) as
shown.

3. Reconnect Flame to Handle and turn
clockwise to lock.

TM

Hanging the Torch

The Torch Hanger is
only intended to
mount on a vertical
wall.

To Turn On:

Twist the ame clockwise

Twist the ame counter
clockwise to turn o.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD

Questions? Visit unclemilton.com

Locate stud in wall or
use the wall mounting
hardware included to
mount the Torch
Hanger to the wall as

shown.

2085- 0250-1012-V02

BATTERY SAFETY INFORMATION

• Non-rechargeable batteries are not to be recharged

• Rechargeable batteries are to be removed from the toy before being charged

• Rechargeable batteries are only to be charged under adult supervision

• Dierent types of batteries or new and used batteries are not to be mixed

• Batteries are to be inserted with the correct polarity

• Exhausted batteries are to be removed from the toy

• The supply terminals are not to be short-circuited

• Do not mix old and new batteries

• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries

• Do not dispose of batteries in re. Battery may explode or leak.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

Caution: changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

IGS Corporation Limited

2 Merlin Business Park,
Fair Oak Close,
Exeter, Devon, EX5 2UL, UK
Tel: [phone]

Hunter Leisure (Aust) Pty Ltd

94 Keilor Park Drive
Tullamarine, Vic, 3043
Australia N14756

MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.

P.O. Box 6281
THOUSAND OAKS, CA 91359, U.S.A.

©2013 UMI. All rights reserved. ® and
Uncle Milton I ndustries, Inc.
PRINTED IN CHINA

TM

designate trademarks of