Uncle Milton Thor Lightning Energy Hammer User Manual

“WHOSEVER HOLDS THIS HAMMER, IF HE BE

“WHOSEVER HOLDS THIS HAMMER, IF HE BE

WORTHY, SHALL POSSESS THE POWER OF....THOR”

WORTHY, SHALL POSSESS THE POWER OF....THOR”

PARTS INCLUDED

- 1 Thor Hammer

- 1 Display Base

- 1 Energy Charge Coin

BATTERY INSTALLATION

Tool required - Small Phillips head screwdriver

1. Using a Phillips head screwdriver, remove
the battery cover as shown.

2. Insert 3 "AAA" batteries as indicated in the
battery compartment and replace cover.

ACTIVATING THOR’S HAMMER

Now you can harness the power and energy of Thor’s Lightning Hammer! Use it to
nd and detect metal. Then, watch as it ashes and sizzles with lightning energy.

First, test the energy charge of your hammer. Touch the Energy Plate on the top of
Thor’s Hammer to the Energy Charge Coin. Watch as this activates the light and
sound of Thor’s hammer.

Then, go on your own mission to detect other metals that will activate
Thor’s Hammer.

For each metal object you nd, touch the Energy Plate on the top of the hammer
against it to see if it will activate with a charge of energy. If it does, you have
successfully found iron-containing metal, also known as ferrous metal, which is the
key ingredient needed to charge Thor’s Hammer.

Energy Charge

Coin

Energy

Plate

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.

Caution: changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

BATTERY SAFETY INFORMATION

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the toy before being charged.

• Rechargeable batteries are only to be charged under adult supervision.

• Dierent types of batteries or new and used batteries are not to be mixed.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short-circuited.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

• Do not dispose of batteries in re. Battery may explode or leak.

6+

18019

AAA/LR03

Batteries not included

x3

Requires 3 x 1.5V AAA/LR03 batteries

DISPLAYING THOR’S HAMMER

After returning from your mission, rest Thor’s Hammer in its base
and it will activate a nal charge of energy. After the sound of the
charge is complete, the light coming from the hammer will continue
for approximately 15 minutes. Then, it will automatically shut-o.

Energy
Charge
Coin

Hammer

Base

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD

Questions? Visit unclemilton.com

MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.

P.O. Box 6281
THOUSAND OAKS, CA 91359 USA

©2013 UMI. All rights reserved. ® and
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA

TM

designate

© Marvel

18019-0250 -0513-V02