Uncle Milton Fireworks Light Show Launcher User Manual

FIREWORKS LIGHT SHOW

5+

2170

IMPORTANT: For best rework projection, use
in a completely darkened room and project
onto a white wall or ceiling from a distance of
4 to 5 feet.

IN MY ROOM

Incredible Fireworks Lightshow Launcher

1

CAUTION: Do not look directly into the

light source.

BATTERY INSTALLATION

Tool required - Small Phillips head screwdriver

1. Using a Phillips head screwdriver, remove the
battery cover as shown.

2. Insert 3 "AA" batteries as indicated in the
battery compartment and replace cover.

Batteries not included

A A / L R 6

x3

Requires 3 x 1.5V AA/LR6 batteries

2

3

BATTERY SAFETY INFORMATION

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the toy

before being charged.

• Rechargeable batteries are only to be charged

under adult supervision.

• Different types of batteries or new and used batteries

are not to be mixed.

• Batteries are to be inserted with the correct polarity.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

MANUFACTURED BY UNCLE MILTON
INDUSTRIES, INC.

P.O. Box 6281
THOUSAND OAKS, CA 9135 9 USA

©2012 UMI. All rights re served. ® and
trademarks of Un cle Milton Industrie s, Inc.

MADE IN CHINA

TM

designate

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short-circuited.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.

• Do not dispose of batteries in re. Battery may
explode or leak.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD

Questions? Visit unclemilton.com

Slide power switch to ON position. Rotate
rework selector to set rework image.

ON/OFF Switch

Pull back and release lower grip to shoot
rework, and wait to hear launch sound eect.

After launch sound eect, pull trigger to make
the rework burst.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.

Caution: changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.

2170-0250- 0312