UNRF5-M22 module UM
For evaluation need MDK board
Chapter 1
Introduction
The nRF5 Mesh Development Kit includes hardware, firmware source code, documentation, hardware
schematics, and layout files.
The key features of the development kit are:
• nRF5-M22™ ANT/ANT+, Bluetooth® low energy 5.0 and mesh Module
• Buttons and LEDs for user interaction
• I/O interface for DIP-24 form factor plug-in socket, for motion and environmental sensors
• SEGGER J-Link debugger interface, 10 pins and 1.27mm pitch
• Supporting NFC-A listen mode
• USB/external power or double AA batteries power source
• IPEX to SMA connector, enable external high gain antenna
• System current consumption measure interface
For access to firmware source code, hardware schematics, and layout files, see www.ultune.com.
Figure 1: nRF5 Mesh Development Kit board
Chapter 2
Setting up the mesh DK
Before you start developing, prepare your development kit hardware by completing a few easy steps and
download the required software.
1. To set up the hardware, follow the instructions in Getting started with the nRF5 Mesh Development
Kit.
2. To set up the software, follow the instructions in Nordic tools and downloads in nRF5 Getting
Started. Actual software required depends on your OS and Development IDE.