Ultravation Umx1200t, Umx1202t, Umx1902t, Umx1900t Owner's Manual
ULTRAMAX GOLD UMX REMOTE LAMP
AIR DISINFECTION SYSTEMS w/ ODOR REDUCING
TECHNOLOGY (PCO)
OWNERS GUIDE
Models: UMX-1200T/ UMX-1900T / UMX-1202T/ UMX-1902T – 120-240VAC Power Input with Remote Mount Lamps
Table of Contents:
Page 2 – Shipping and Packing list, Safety Precautions
Page 3-4 – General Application Guidelines and Recommended Installation
Page 5 – Installation Steps for External Remote Lamp Mounting with External Mounting of Power Supply, and Internal
Remote Lamp Mounting with External Mounting of Power Supply
Page 6 – Installation Steps for Re-Fresh PCO Module
Page 7 –Maintenance, Troubleshooting, Lamp Replacement and Reset Procedure
Page 8 –UV Lamp Monitor, Power Consumption and Replacement Part Number, Warranty
LEAVE FOR HOMEOWNER
DC-IH-0216
Shipping and Packaging List:
• UMX Electrical Housing
• Ultra-Ion Re-fresh PCO module w/ gasket
• 6- ¾ inch 5/16 self tapping sheet metal screws
• 6’ Electrical Housing power cord
• Warning Label
• Residential Warranty Card
UMX- 1200T, 1202T, 1900T, 1902T
• **1200T and 1900T Series- 1 12” or 17” T3
Lamp
• **1202T and 1902T Series- 2 12” or 17” T3
Lamp
• *8 or 12 PCO module and T3 Lamp mounting
plate mounting screws
• *2 or 4 T3 Lamp mounting screws
• *1 or 2 T3 Lamp mounting plate
* Number depends on 1 or 2 T3 Lamps
** T3 Lamp gasket included
Safety Precautions:
It is recommended that this unit be installed and
maintained by a trained technician:
WARNING: UV Hazard. Always protect eyes from
ultraviolet light. NEVER look at UV lamps in
operation. Unplug or disconnect power before relamping or servicing.
WARNING: Severe eye damage or temporary
blinding may occur.
WARNING: DO NOT operate outside of Air Handler.
Mount lamp base to duct first.
WARNING: No openings in duct are allowed which
would give direct line-of-sight to the UV light.
In the event of accidental breakage or replacement of
the ultraviolet lamp, please ensure that the lamp is
disposed of in accordance with local and state
environmental laws regarding fluorescent lamps
containing mercury.
Notice:
All wiring inside of the duct or air handling system in
direct line of site of the UV lamp must be shielded with
aluminum foil tape or equivalent non-combustible
material. When installing this unit, select a mounting
location that prevents ultraviolet light exposure to
plastic flexible duct liner or other plastic components
with unknown resistance to ultraviolet light. Ultraviolet
light may cause color shift or structural degradation of
plastic HVAC components
www.ultravation.com
2
General application guidelines for Ultramax Ultraviolet air purification systems
p
Horizontal
Up Flow
**Up Flow
Ultravation manufactures several configurations
of Ultraviolet disinfection products to meet any
installation criteria. Ultravation two lamp
ultraviolet systems are designed to adequately
treat up to a 5 ton system or 3,500 sq ft.
Whenever possible use a two lamp configuration
with the longest lamp length possible for the
installation.
Ultravation suggests mounting on the exit side of
the HVAC system before the ductwork branches
off. This will ensure that the airborne
contaminants reaching the ultraviolet purification
system and the Re-Fresh Odor reduction module
have been reduced to an acceptable Micron size
by the HVAC systems filter.
Ultravation Ultramax products have been
designed for peak performance in the cooler
temperatures commonly found in the supply
plenum of a typical HVAC system.
Installing an Ultraviolet system in the return may
degrade the media filter and/ or collect dirt
particles on the UV lamp glass gradually
decreasing performance. If this is the obvious
source of microbial growth then placing the
Ultraviolet system in the return is the best
solution. **Caution must be taken to ensure
Ultraviolet light is not coming in contact with
the media filter or being exposed outside the
enclosed system.
Ultravation’s exclusive Re-Fresh odor reduction
module performs continuous photo catalytic
processing, constantly reducing or eliminating
unwanted odor and bacteria resulting in clean
fresh breathable air.
Ultravation Ultraviolet systems produce no
ozone. There is no harmful by-products or off
gasing taking place in the sterilization process or
the photo catalytic process.
The surrounding illustrations show the flexibility
offered with the Ultravation Ultramax product line
actual installation may vary depending upon
installation criteria, if you need help or have
questions call our toll free help line:
1-866-GO-UV-AIR 468-8247 ext 16
9:00 am – 5:00 pm Est.
Up Flow
**U
Horizontal
Flow
www.ultravation.com
3
Loading...