Ultravation 92-022, 92-023, 92-141 Owner's Manual

Photronic Stand Alone HEPA

Owners Guide

Models: 92-022, 92-142 (200-350 CFM)
Models: 92-023, 92-141 (650-950 CFM)

Table of Contents:

Page 2- Shipping and Packaging list, Introduction and Application, Safety Precautions, Power Consumption

Page 3-

Page 4- Troubleshooting, Warranty, Replacement Part Numbers

Maintenance, Replacing Filter, Replacing Photo catalytic Lamps

LEAVE FOR HOMEOWNER

DC-IH-0211

Shipping and Packaging List:

• Filter Housing including Access Door

• Merv 11 Media Air Filter

• *HEPA Filter

• PCO Filter

• Electrical Enclosure

• 2- 12” UVC Lamps

* If the option was purchased

Introduction and Applications:

This Ultravation Stand Alone Photronic HEPA is a stand
alone air cleaning system. This high efficiency air
filtration unit is designed to remove dirt, dust, pollen, and
microscopic particles: reduce unpleasant odors, VOC
gases and the microbial population from the air that
circulates through it. By adding this device to your HVAC
system, you are helping to create a cleaner indoor living
environment for your whole household.

The system works in 2-3 steps (depending on model
purchased, some models do not include the germicidal
protection in step 3)

STEP 1: Trapping particles in the pleats of the MERV 11
media filter. With an extra large surface area, the filter
allows for maximum dirt holding capacity and a long,
useful filter life with minimum air flow restriction.

STEP 2: VOC’s and gases such as the f umes from new
carpets, paints, nail polish, cigar and cigarette smoke
are drastically reduced photo chemically via a patented
process known as photo catalytic conversion or photo
catalytic oxidation.

STEP 3: Germicidal UVC light is applied to the Air to
drastically reduce or eliminate unwanted virus, bacteria
and mold.

This air cleaner is to be installed in a forced air heating,
cooling and ventilation system. It should be installed so
that all the system’s air is circulated through the filter first
and VOC Section second. The air cleaner will only filter
the air that is circulated through it. For maximum filtration
effect, set your blower to operate continuously. (Lower
speeds allow for higher efficiency)

Safety Precautions:

It is recommended that this unit be installed and
maintained by a trained technician:

WARNING: UV Hazard. Always protect eyes from
ultraviolet light. NEVER look at UV lamps in
operation. Unplug or disconnect power before re­lamping or servicing.

WARNING: Severe eye damage or temporary
blinding may occur.

WARNING: DO NOT operate outside of Air Handler.
Mount lamp base to duct first.

WARNING: No openings in duct are allowed which
would give direct line-of-sight to the UV light.

In the event of accidental breakage or replacement of
the ultraviolet lamp, please ensure that the lamp is
disposed of in accordance with local and state
environmental laws regarding fluorescent lamps
containing mercury.

Notice:

All wiring inside of the duct or air handling system in
direct line of site of the UV lamp must be shielded with
aluminum foil tape or equivalent non-combustible
material. When installing this unit, select a mounting
location that prevents ultraviolet light exposure to
plastic flexible duct liner or other plastic components
with unknown resistance to ultraviolet light. Ultraviolet
light may cause color shift or structural degradation of
plastic HVAC components

Power Consumption UV-A, UV-C lamps

Lamp Type
12-inch UVC lamp is 16 watts each 2
Note: Handle fits either door. A Phillips screw driver

will be required to install the handle. Handle holes are
behind the label on either door, depending on the
orientation of the installation.

Quantity Required

2