Ultratec True North Snow Fluid Data Sheet
Product Identifier
SDS No.
Product Family
SECTION 1. IDENTIFICATION
Supplier
Manufacturer
Date of Preparation
True North Snow Fluid
GHS Label Elements
SECTION 2. HAZARDS IDENTIFICATION
Not applicable
GHS Classification
Not classified under any GHS hazard classes.
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name CAS No. Other Identifiers%
Disodium Cocoamphodipropionate 68604-71-7 3-7
Inhalation
Get medical advice/attention if you feel unwell or are concerned.
Skin Contact
Wash gently and thoroughly with lukewarm, gently flowing water and mild soap for 5 minutes. Get medical
advice/attention if you feel unwell or are concerned.
Eye Contact
Immediately flush eye(s) with plenty of water. If eye irritation persists, get medical advice/attention.
Ingestion
Do not induce vomiting. Rinse mouth with water.
First-aid Comments
Get medical advice/attention if you feel unwell or are concerned.
SECTION 4. FIRST-AID MEASURES
First-aid Measures
Suitable Extinguishing Media
Not combustible. Use extinguishing agents compatible with product and suitable for surrounding fire.
SECTION 5. FIRE-FIGHTING MEASURES
SDS No.:
Date of Preparation:
0059 Page
of
0301
April 22, 2015
Product Identifier: Snow Fluid EP
Special Effects Snow Fluid
Ultratec Special Effects
1960 Blue Heron Drive
London, Ontario, Canada
519-659-7972
0059
April 22, 2015
Safety Data Sheet
True North Snow Fluid
Personal Precautions, Protective Equipment, and Emergency Procedures
Use the personal protective equipment recommended in Section 8 of this safety data sheet.
Environmental Precautions
It is good practice to prevent releases into the environment.
Methods and Materials for Containment and Cleaning Up
Stop or reduce leak if safe to do so. Contain and soak up spill with absorbent that does not react with spilled product.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Precautions for Safe Handling
No special precautions are necessary.
Conditions for Safe Storage
Separate from incompatible materials (see Section 10: Stability and Reactivity).
SECTION 7. HANDLING AND STORAGE
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Appropriate Engineering Controls
Individual Protection Measures
Skin Protection
Respiratory Protection
Eye/Face Protection
Not normally required if product is used as directed.
Use personal protective equipment as required.
Polyethylene, neoprene rubber, natural rubber.
Wear chemical safety goggles.
General ventilation is usually adequate.
pH 7 - 9
Appearance Clear colourless.
Initial Boiling Point/Range 100 ºC (212 ºF)
Relative Density (water = 1) 1.007
Solubility Soluble in water
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Basic Physical and Chemical Properties
LiquidPhysical State
Other Information
Chemical Stability
Normally stable.
Incompatible Materials
Strong oxidizing agents (e.g. perchloric acid).
SECTION 10. STABILITY AND REACTIVITY
LC50: No information was located.
SECTION 11. TOXICOLOGICAL INFORMATION
Acute Toxicity
SDS No.:
Date of Preparation:
0059 Page
of
0302
April 22, 2015
Product Identifier: Snow Fluid EP
Loading...