Ultratec G3000 Users Manual
G3000 Fog Effects Generator
Operator’s Manual
www.ultratecfx.com
VER. 22.10.14
Table of Contents
Introduction ................................................................................ 3
Microprocessor Control ............................................................3
Water Base Fog Technology ...................................................... 3
Warning ...................................................................................... 3
Important Safety Instructions: ................................................... 3
Safety Precautions ..................................................................... 3
Technical Specications ............................................................. 4
Technical Drawings ................................................................... 4
Operating Procedure ................................................................. 5
Digital Remote Control .............................................................. 5
G3000 Screen Shots ................................................................. 7
DMX Operation .......................................................................... 9
Other Features ........................................................................... 9
Remote Extension ..................................................................... 9
Fluid Level Detection ................................................................. 9
Maintenance ............................................................................... 9
Exterior ..................................................................................... 9
Heat exchanger ........................................................................ 9
Recommended Fluids ............................................................... 10
Maintenance Fluid .................................................................. 10
Warranty ................................................................................... 11
Contact Information ................................................................ 11
www.ultratecfx.com
2
Note: Please read entire manual before operating the G3000 Fog Effects Generator
Introduction
The G3000 Fog Effects Generator is a Microprocessor Controlled, Water Based Fog generating system.
Microprocessor Control
The G3000 features dual microprocessor control. From temperature regulation to taper back ow control, all of
the functions are monitored and processed by the two on-board processors.
Water Base Fog Technology
Water Base Fog technology is achieved by pumping a glycol/water mixture through a heat exchanger. This will
vaporize the uid as it passes through the processing block. The vaporization of the uid forces the hot mixture
through the output nozzle. When mixed with ambient air, it forms an opaque aerosol (fog). The fog is made up of
tiny droplets that form around small particles in the air. The suspended droplets refract the light, allowing the fog
to take on the color of the light illuminating it.
Warning
Important Safety Instructions:
1. Do not touch, place hands or expose skin within 20” (50 cm) of the discharge nozzle.
2. Do not remove the outer case.
3. Persons suffering from asthma or allergenic sensitivity may experience irritation, discomfort or allergic
symptoms when exposed to fog effects.
4. Ensure that this unit is grounded at all times. Failure to do so may result in serious injury.
5. Use Ultratec Special Effects uid ON LY.
Safety Precautions
1. Ensure that any operation of the machine is supervised by suitably trained and authorized personnel.
2. Do not modify the machine or use a machine which has been damaged in any way.
3. Allow sufcient air circulation around the machine at all times.
4. Protect the machine from direct weather effects and wet locations.
5. Only use uids manufactured by Ultratec Special Effects.
6. Do not continue to produce fog when visibility is reduced to 20” 50cm or below.
7. Avoid directing fog output continuously at people, structures or objects within close proximity of the discharge
nozzle.
8. Ensure that adequate exhausting arrangements are available in the event of an emergency.
9. Do not place hands or exposed skin within the rst 20” (50 cm) of the discharge nozzle at any time during fog
production.
10. Fog effects can trigger smoke alarms and detectors. Please take suitable precautions to prevent false alarms.
www.ultratecfx.com
3
Technical Specications
Model: G3000 Fog Effects Generator
Part Number: CLF 3000 - G3000 Fog Machine / 120 Volt
CLF-3001 - G3000 Fog Machine / 120 Volt - w/ Air Option
CLF-3002 - G3000 Fog Machine / 120 Volt - w/ Industrial Option
CLF-3003 - G3000 Fog Machine / 220-240 Volt
CLF-3004 - G3000 Fog Machine / 220-240 Volt - w/ Industrial Option
CLF-3006 - G3000 Fog Machine / 220-240 Volt - w/ Air Option
CLF-3007 - G3000 Fog Machine / 120 Volt - w/ Show Control
CLF 3008 - G3000 Fog Machine / 105 Volt
Length: 25.38in 59.37cm
Width: 10.5in 26.67cm
Height: 10.63in 66.98cm
Net Weight: 52lbs 24kg
Power Rating: 120 Volt A.C. 50/60 Hz. 17 Amps.
240 Volt A.C. 50/60 Hz. 9 Amps.
Fluid: Water Base Fog Fluid (Use only Ultratec Fluid)
Features: 2000w Dual Core Heating Block
Technical Drawings
www.ultratecfx.com
4
Loading...