Ultratec Bubble Master Fluid Data Sheet

Product Identifier

SDS No.

Product Family

SECTION 1. IDENTIFICATION

Supplier

Manufacturer

Date of Preparation

Bubble Master Fluid

GHS Label Elements

SECTION 2. HAZARDS IDENTIFICATION

Not applicable

GHS Classification

Not classified under any GHS hazard classes.

SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical Name CAS No. Other Identifiers%

Anionic/Non-ionic Surfactant Blend N/A 1-5

Inhalation

Get medical advice/attention if you feel unwell or are concerned.

Eye Contact

Immediately flush eye(s) with plenty of water. If eye irritation persists, get medical advice/attention.

Ingestion

Do not induce vomiting. Rinse mouth with water.

First-aid Comments

Get medical advice/attention if you feel unwell or are concerned.

SECTION 4. FIRST-AID MEASURES

First-aid Measures

Suitable Extinguishing Media

Not combustible. Use extinguishing agents compatible with product and suitable for surrounding fire.

SECTION 5. FIRE-FIGHTING MEASURES

Personal Precautions, Protective Equipment, and Emergency Procedures

Use the personal protective equipment recommended in Section 8 of this safety data sheet.

SECTION 6. ACCIDENTAL RELEASE MEASURES

SDS No.:
Date of Preparation:

0070 Page

of

0301

June 11, 2015

Product Identifier: Bubble Master 2000

Special Effects Bubble Fluid

Ultratec Special Effects
1960 Blue Heron Drive
London, Ontario, Canada
519-659-7972

0070
June 11, 2015

Safety Data Sheet

Bubble Master Fluid

Environmental Precautions

It is good practice to prevent releases into the environment.

Methods and Materials for Containment and Cleaning Up

Stop or reduce leak if safe to do so. Contain and soak up spill with absorbent that does not react with spilled product.

Precautions for Safe Handling

No special precautions are necessary.

Conditions for Safe Storage

Separate from incompatible materials (see Section 10: Stability and Reactivity).

SECTION 7. HANDLING AND STORAGE

SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Appropriate Engineering Controls

Individual Protection Measures

Skin Protection

Respiratory Protection

Eye/Face Protection

Not normally required if product is used as directed.

Use personal protective equipment as required.
Polyethylene, neoprene rubber, natural rubber.

Wear chemical safety goggles.

General ventilation is usually adequate.

pH 7.0 - 7.5

Appearance Clear colourless viscous.

Initial Boiling Point/Range 100 ºC (212 ºF)
Relative Density (water = 1) 1.0
Solubility Soluble in water

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Basic Physical and Chemical Properties

LiquidPhysical State

Other Information

Chemical Stability

Normally stable.

Incompatible Materials

Strong oxidizing agents (e.g. perchloric acid).

SECTION 10. STABILITY AND REACTIVITY

LC50: No information was located.
LD50 (oral): No information was located.

Skin Corrosion/Irritation

SECTION 11. TOXICOLOGICAL INFORMATION

LD50 (dermal): No information was located.

Acute Toxicity

SDS No.:
Date of Preparation:

0070 Page

of

0302

June 11, 2015

Product Identifier: Bubble Master 2000