Ultra Start KE-4 User Manual
INSTALL GUIDE
U.S.A. Model
KE-4 KEYLESS ENTRY SYSTEM
WWW.ULTRASTARTERS.COM
Technical Support 866-698-5872 ext 0
Support@ultrastarters.com
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance
void the user’s authority to operate this devise.
Installation Manual
KE-4
Table Of Contents....................................................................................... Page 2
System Contents.
Pre-Installation.
Installation Tips.
Main Wiring Diagram................................................................................... Page 3
Quick Start Installation................................................................................ Page 4
Wiring Description.
Transmitter Operation.
Transmitter Programming........................................................................... Page 5
System Reset
Quick View Programming Chart
System Programming................................................................................. Page 6
System Programming.................................................................................. Page 7
Relay Diagrams........................................................................................... Page 8
System Contents Key Features
- Control Module
- Four Button Remote
Transmitter(s)
- 10-Pin Harness
- Installation Guide
- Owners Manual
Pre-Installation
BEFORE STARTING:
- Discuss the optional features of the alarm with the owner of the vehicle.
- Do a walk around of the vehicle. (Note any scratches or dents)
- Check with the vehicle’s owner before installation of LED light.
- See if the owner has a preference for the location of the Valet Switch.
- Have vehicle wiring information ready before starting installation.
Installation Tips
- Leave a window open to avoid locking the key’s in the vehicle.
- Use seat covers and floor mats to protect the vehicle.
- Avoid disconnecting the battery.
- Unplug the dome light fuse to prevent battery drain.
- Test all connections with a voltmeter or circuit safe test light.
- Install the wire harness so that it is free of any moving parts.
- Solder all connections. Avoid using scotch-lok and crimp connectors.
- Pull the siren and optional hood pin wires through a factory rubber grommet
into the engine compartment.(Do not use the steering boot).
- Install the siren away from high heat sources and direct exposer to water.
- Keyless Entry With Drivers Door Priority
- Trunk Release Output
- Positive Park Light Output
- Panic Mode
- Horn Honk Output
- Starter Disable Output
Installation Manual
KE-4
15 Amp Output
Ground Input
Constant 12 volts
Ignition Input
500ma Output
500ma Output
500ma Output
500ma Output
Park Lights (+)
Chassis Ground
Main Power (+)
Ignition (+)
2nd Unlock (-)
1st Unlock (-)
Lock (-)
Trunk Rel. Out (-)
White
Black
Red
Yellow
Pink
Blue
Green
Gray
LT
-
+
10- Pin Connector
IG
Un2
UN
LK
Ch2
500ma Output
500ma Output
***500ma outputs are low current and are designed to activate relays.
(-) Horn Honk
Starter Kill (+)
Antenna - Do Not Ground the
antenna wire.
Brown
Orange
HR
ST
Loading...