Ultra Start 606, 660, 640, 670 User Manual

Rev. 2006.02

Advanced Remote Vehicle Security Systems

www.ultrastarters.com

FCC/ID Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:

1. This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the
user’s authority to operate this devise.

OWNER’S MANUAL PAGE 2

Table Of Contents

Table Of Contents Page 2
Alarm Functions Pages 3-5

Arm System
Disarm System
Priority Unlock*
Silent Arm/Disarm
Panic
Trunk Release*
Auxiliary #1 (Ch 4)* False Alarm Circuit
*(optional features)

Shock Sensor Page 6

Shock Sensor Programming/Adjustments
Temporary Shock Sensor Bypass

LCD Display (660/670 series)

Icon Descriptions
Setting The Time
Programmable Icons
Setting “Vibra” Mode (670 ONLY)

Remote Transmitters Pages 11-12

Transmitter Programming
Battery Replacement

Car Jack Mode Page 13
Service Mode (Valet) Page 14
Diagnostics Page 15

Diagnostics Chart
Additional LED Flashes

Product Warranty Page 16

This Manual Covers the Following Series:

Auxiliary #2 (Ch 5)*
Car Finder
Ignition Auto Locks*

Passive Arming*

Starter Disable*

Dome Light Supervision*

Pages 7-10

640 / 606 / 660 / 670

PAGE 3 OWNER’S MANUAL

Alarm Functions

Arm System

1. Press and release the button on the remote transmitter.

2. The park lights will flash and the siren will chirp one time.

3. The doors will lock (optional).

4. The LEDs on the antenna will start flashing within five seconds.

Disarm System

1.Press and release the button on the remote transmitter.

2.The park lights will flash and the siren will chirp two times.*

3.The doors will unlock (optional).

4.The LEDs on the antenna will stop flashing.

* If the system was triggered, the system will respond with two park light flashes
and three siren chirps. See Page 9 for Diagnostics.

NOTE: If the system is triggered, example: opening the door before disarming
the system. The first press and hold of disables the siren ONLY!

A second press and release of disarms the system.

Priority Unlock Feature (optional)

1. Press and release the button on the remote transmitter. The park lights will
flash, the siren will chirp two times and the drivers door will unlock.

2. Press and release the button again and the remaining doors will unlock.

NOTE: The must be pressed a second time within 3sec (606/640 series),
press and release a second after 3sec (660/670 series).

Silent Arm and Disarm

Press and release the and buttons simultaneously.

If the system was armed this will disarm the system.
The park lights will flash twice without siren chirps as confirmation.

If the system was disarmed, this will arm the system.
The park lights will flash one time without siren chirps as confirmation.

OWNER’S MANUAL PAGE 4

Alarm Functions

Panic Mode

Activating Panic Mode

Press and hold the button for three seconds. The park lights will begin to flash
and the siren will activate.

Disabling Panic Mode

Press and release the or button to disable Panic.

NOTE: Panic mode will stay activated for sixty seconds.

Trunk Release Ch 3 (optional)

Press and hold the button. The system will disarm, unlock the doors and
continue to hold the button until the trunk release activates.
This will be confirmed by one park light flash and one siren chirp.

Note: The trunk release output will not activate when the ignition key is in the
“On” position.

Auxiliary Output Ch 4* (optional)

1. Press and hold the button. (The button on the 606 series)

2. The park lights will flash and the siren will chirp 1 time.

3. The auxiliary output will stay activated until the button is released.

*Dealer programmable constant, latched or momentary output.

Auxiliary Output Ch 5 (optional)

1. Press and hold the button.

2. The park lights will flash and the siren will chirp 1 time.

3. The auxiliary output will stay activated until the button is released.

NOTE: Auxiliary Output Ch 5 not available on the 670 series.

(The button on the 606 series)

PAGE 5 OWNER’S MANUAL

Alarm Functions

Car Finder Mode (not available on the 670)

1. Press and hold the button for three seconds.

2. The park lights will flash and the siren will chirp five times to draw attention to
the location of the vehicle.

Ignition Auto Locks (optional)

1) The system will lock the doors 2 seconds after the ignition key is
turned to the “on” position.

Ignition

On/Off

2) The system will unlock the doors when the ignition key is turned
to the “off” position.

Passive Arming (optional)

The system will automatically arm and lock (optional) the doors 30 seconds
after the last door is closed. It may also be programmed to arm and lock
(optional) the doors if the button is pressed and a door is not opened.

Starter Disable (optional)

The system will interrupt the vehicles starter when the system is
armed and allow the vehicle to start when the system is disarmed.

Dome Light Supervision (optional)

The system will activate the dome light for 30 seconds when the button is
pressed.
NOTE: Dome light will shut off after 30 sec. or until the key is turned “ON”.

False Alarm Circuit

The system is designed to prevent ongoing shock sensor triggers. If the shock
sensor is triggered more then 3 times within one hour the system will ignore the
sensor until the alarm is disarmed then armed again.