Ultra Start 45xx User Manual
Covers All 45xx Series 2way Remote Starter/ Alarms
-The system must be placed into Service Mode before any service work is started on the vehicle. It is
the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no
liability or responsibility for accidental starting of the vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
- The Hood Pin Safety Switch Must Always be Installed!
- Never Install Automatic Transmission Remote Starters into a Manual Transmission Vehicle!
OWNER’S GUIDE
Page 2
2way REMOTE STARTER/ ALARM
Welcome
Congratulations on your purchase of an Ultra Start remote vehicle starter with
alarm system. Ultra Start remote vehicle starters and alarms will provide years
of security, comfort and convenience. To utilize and understand this system to the
fullest, please read this manual in detail.
About Ultra Start
It is our continuing objective to design and manufacture the absolute best
Remote Car Starters, Vehicle Security Systems, Keyless Entry Systems and
Security Bypass units available in today’s competitive market. This objective is
met by utilizing installation professionals with decades of industry experience to
assist in each step of the design process. This has allowed us to build products
that are very installer and user friendly yet offer advanced and innovative
features. Our systems utilize intelligent programming and auto learning systems
and are designed to work properly in every vehicle. Our systems are also
designed wherever possible to be up-gradable, allowing the consumer and the
retailer to enjoy easy and cost effective upgrades and additions to their system
down the road. Our limited lifetime warranty provides one of the best protection
plans in the industry, giving both the consumer and the retailer confidence when
they invest in an Ultra Start product.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation of this device is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part
responsible for compliance voids the users authority to operate this device.
2WAY REMOTE STARTER/ ALARM
Remote Start - Automatic Transmission
1. Press and release button #3.
2. The park lights will flash and the siren will chirp one time.
3. The vehicle will then remote start. The park lights will flash four
2
3
1
4
times then remain on while the vehicle is running. The run timer
on the LCD will begin to countdown.
4. The vehicle will continue to run for the programmed runtime*.
Never remote start if the vehicle is parked in a Garage.
Operate in a well ventilated area only.
Note: If the remote starter fails to start, the park lights will flash a
OWNER’S GUIDE
Page 3
Trouble Shooting Code. Count the number of flashes and
refer to the Diagnostics Chart on page 15.
Remote Stop
2
3
1
4
1.Press and hold button #3 for three seconds. The remote starter
will shut down. The park lights will flash and the siren will chirp
two times to confirm shutdown.
Note: Pressing the brake pedal or opening the hood will also shut
down the remote starter.
Extended Run Time
2
3
1
4
1.Press and release button #3 while the vehicle is running.
2.The system will respond with one park light flash and one siren
chirp to confirm Extended Runtime.
The system will reset the run time*.
Note: Extended runtime will not work if the runtime is programmed
for 4 Minutes.
*Default 15 minutes
OWNER’S GUIDE
Page 4
Idle Mode
1. While the vehicle is running with key, press button #3.
2
3
1
4
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key off and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without leaving the
keys in the Ignition.
Note: Always lock the doors while the vehicle is left running
unattended. The vehicle will stay running for the
programmed runtime (Default 15 minutes)
2way REMOTE STARTER/ ALARM
Turbo Timer Mode
2
3
1
4
1.While the vehicle is running with key, press button #4.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key off and the vehicle will continue to run for
approximately 2 minutes.
Note: Always lock the doors while the vehicle is left running
unattended.
Status Update
2
3
1
4
This feature is used to check the status of the vehicle. If the
system does not update the remote after completing a function
press Button #4 on the transmitter. The remote will then display the
current status of the system on the LCD screen.
If the system is out of operating range the remote transmitter will
beep three times quicky after a button is pressed. The antenna icon
on the top of the LCD will be gone or show no bars next to the icon.
2WAY REMOTE STARTER/ ALARM
OWNER’S GUIDE
Page 5
Reservation Mode- Manual Transmission Only
Manual transmission remote starters must be set into Reservation Mode before
the remote starter will activate. There are two different ways to place the system
into Reservation Mode. The activation type of Reservation Mode is determined
when the system is installed. The default setting is Auto Reservation Mode.
Auto Reservation Mode
Step 1 - While the vehicle is running with the key, place the transmission into neutral
and apply the park brake.
Step 2 - Press and release the brake pedal twice. The park lights will flash twice,
the siren will chirp twice and the doors will unlock (optional).
Step 3 - Turn the ignition key off and the vehicle will continue running.
Step 4 - Exit the vehicle and close all the doors. The vehicle will then shut off *.
Manual Reservation Mode (Dealer Programmable Feature)
Step 1 - While the vehicle is running with the key, place the transmission into neutral
and apply the park brake.
Step 2 - Press and release button #4. The park lights will flash twice, the siren
will chirp twice and the doors will unlock (optional).
Step 3 - Turn the ignition key off and the vehicle will continue running.
Step 4 - Exit the vehicle and close all the doors.
Step 5 - Press and hold button #3 for 3 seconds, the vehicle will then shut off.
*****THE VEHICLE MAY NOW BE SAFELY REMOTE STARTED.*****
(See pages 3&4 for Remote Starter Functions.)
If Reservation Mode is not set, the remote starter will not activate. When
button #4 is pressed the park lights will flash 4 times. 4 flashes is the diagnostic
code for “Not in Reservation Mode”
Note: Reservation Mode will reset if the doors of the vehicle are opened. To re-enter
the vehicle without canceling the Reservation Mode (forgot something..) The
vehicle must first be remote started. While the vehicle is running the door may
be opened, when done in the vehicle, close the door and hold button #3
until the remote starter shuts off.
* If the vehicle has dome light delay, the vehicle may stay running until the dome
light turns off. This is normally no longer than 30 seconds.
Loading...