Ultra Start 3561M SERIES Owner's Manual

Covers All 35xx Series 2way Remote Starter/ Alarms

-The system must be placed into Service Mode before any service work is started on the vehicle. It is
the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no
liability or responsibility for accidental starting of the vehicle.

- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)

- The Hood Pin Safety Switch Must Always be Installed!

- Never Install Automatic Transmission Remote Starters into a Manual Transmission Vehicle!

OWNER’S GUIDE 2WAY REMOTE STARTER

Page 2

Table of Contents

Table of Contents Page 2
Welcome Page 3

Feature List

About Ultra Start

FCC Notice

Remote Starter Functions Page 4-5

Remote Starting
Remote Stop

Extended Run Time
Idle Mode

Turbo Timer Mode

Status Update

Reservation Mode (Manual Transmission Vehicles) Page 6

Lock/Unlock Features (Optional) Page 7

Lock Doors
Unlock Doors
Priority Door Unlock

LCD Display Page 8-9

Status Icons
Programmable Features

Optional Features Page 10-11

Car Finder Mode
Panic Mode

Trunk Release
Auxiliary Output 1
Auxiliary Output 2

Cold Start/Temperature Start Modes Page 12

Service Mode Page 13

Emergency Service Mode

Remote Transmitter Page 14

Setting Time
Silent Operation

Diagnostics Page 15

Diagnostic Charts
Diagnostic Memory

Product Warranty Page 16

2WAY REMOTE STARTER

OWNER’S GUIDE

Page 3

Welcome

Congratulations on your purchase of an Ultra Start remote vehicle starter with
alarm system. Ultra Start remote vehicle starters and alarms will provide years
of security, comfort and convenience. To utilize and understand this system to the
fullest, please read this manual in detail.

About Ultra Start

It is our continuing objective to design and manufacture the absolute best
Remote Car Starters, Vehicle Security Systems, Keyless Entry Systems and
Security Bypass units available in today’s competitive market. This objective is
met by utilizing installation professionals with decades of industry experience to
assist in each step of the design process. This has allowed us to build products
that are very installer and user friendly yet offer advanced and innovative
features. Our systems utilize intelligent programming and auto learning systems
and are designed to work properly in every vehicle. Our systems are also
designed wherever possible to be up-gradable, allowing the consumer and the
retailer to enjoy easy and cost effective upgrades and additions to their system
down the road. Our limited lifetime warranty provides one of the best protection
plans in the industry, giving both the consumer and the retailer confidence when
they invest in an Ultra Start product.

FCC Notice

This device complies with Part 15 of the FCC rules. Operation of this device is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part
responsible for compliance voids the users authority to operate this device.

OWNER’S GUIDE

Page 4

Remote Starting

1. Press and release button #3.

2. The park lights will flash and the horn (optional) will honk one time.

3. The vehicle will then remote start. The park lights will flash four

2

3

1

4

times then remain on while the vehicle is running. The run timer
on the LCD will begin to countdown.

4. The vehicle will continue to run for the programmed runtime*.

Never remote start if the vehicle is parked in a Garage.

Operate in a well ventilated area only.

Note: If the remote starter fails to start, the park lights will flash a

2WAY REMOTE STARTER

Trouble Shooting Code. Count the number of flashes and
refer to the Diagnostics Chart on page 15.

Remote Stop

2

3

1

4

1.Press and hold button #3 for three seconds. The remote starter
will shut down. The park lights will flash and the horn (optional)
will honk two times to confirm shutdown.

Note: Pressing the brake pedal or opening the hood will also shut

down the remote starter.

Extended Run Time

2

3

1

4

1.Press and release button #3 while the vehicle is running.

2.The system will respond with one park light flash and one horn
(optional) honk to confirm Extended Runtime.

The system will reset the run time*.

Note: Extended runtime will not work if the runtime is programmed

for 4 Minutes.

*Default 15 minutes

2WAY REMOTE STARTER

Idle Mode

1. While the vehicle is running with key, press button #3.

2

3

1

4

2. The park lights will turn on and the horn (optional) will honk once.

3. Turn the ignition key off and the vehicle will continue to run.

4. Exit the vehicle and leave it running safely without leaving the
keys in the Ignition.

Note: Always lock the doors while the vehicle is left running

unattended. The vehicle will stay running for the
programmed runtime (Default 15 minutes)

OWNER’S GUIDE

Page 5

Turbo Timer Mode

2

3

1

4

1.While the vehicle is running with key, press button #4.

2.The park lights will turn on and the horn (optional) will honk once.

3.Turn the ignition key off and the vehicle will continue to run for

approximately 2 minutes.

Note: Always lock the doors while the vehicle is left running

unattended.

Status Update

2

3

1

4

This feature is used to check the status of the vehicle. If the system
does not update the remote after completing a function press
Button #4 on the transmitter. The remote will then display the current

status of the system on the LCD screen.

If the system is out of operating range the remote transmitter will
beep three times quicky after a button is pressed. The antenna icon
onthe top of the LCD will be gone or show no bars next to the icon.