Ultra Start 1250, 1256M User Manual

REMOTE STARTERS

CAR ALARMS

OWNERS GUIDE

This Manual Covers All 1250 Series

U.S.A. Model

Remote Vehicle Starters

ü

WWW.ULTRASTARTERS.COM

FCC/ID Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the user’s
authority to operate this devise.

-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.

- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)

Together

3sec.

Owner’s Guide

BASIC OPERATIONS

Lock Doors

1.Press and release the LOCK button on the remote transmitter.

2.The park lights will flash and the horn (optional) will honk one time.

3.The doors will lock. (With Keyless Entry Option)

4.The LED’s on the antenna will start flashing within five seconds.

Unlock Doors

1.Press and release the UNLOCK button on the remote transmitter.

2.The park lights will flash and the horn (optional) will honk two times.

3.The doors will unlock. (With Keyless Entry Option)

4.The LED’s on the antenna will stop flashing.

Silent Lock And Unlock

1.Press and release the LOCK & UNLOCK buttons at the same time.

2.If the doors are locked this will unlock the doors without horn honks, the park lights will
flash two times to confirm the doors have unlocked.

3.If the doors are unlocked this will lock the doors without horn honks, the park lights will
flash one time to confirm the doors have locked.

Trunk Release

1.Press and hold the UNLOCK button for three seconds.

2.The doors will unlock, continue holding the unlock button for three more seconds, the trunk
release will then activate. The trunk release will be confirmed by one park light flash.

Note: The trunk release output will not activate when the ignition key is in the “On” position.

2 sec.

3 sec.

While
running

2nd Car

Turbo Timer Mode

1.While the vehicle is running with the key, press and release the # button.

2.The park lights will turn on and the horn (Optional) will honk once.

3.Turn the ignition key “Off” and the vehicle will continue to run about 2 minutes.

2nd Car Operation

Press the # button at the same time as the command for the second car. This feature
requires special programming from the dealer.

Press Once to Lock the doors. (Hold For Panic Mode)
Press 2nd Time & Hold for Constant Lock Output

Press Once to Unlock the doors.
Press & Hold for Trunk / Aux Output

Press Once for Start -(2 Times if programmed for Safety Start)
Press & Hold for 3 seconds to turn off the remote starter.

Press & Release then press START and hold for Timer Mode