Page 1
ULTRAMAX UXDV-3HD
FULL High Definition Digital Video Camera
QUICK START GUIDE
IMPORTANT: The DV Camera MUST be set to ALWAYS ON MODE and it must be
POWER ON before inserted to the Underwater DV Housing
Setting the DV Camera to ALWAYS-ON MODE :
Step 1 Step 2
Flip out the LCD panel (or press Flip the LCD Panel clockwise until it faces
the ON/OFF power button) to turn outwards
on the DV Camera
Step 3 Step 4
Choose SETTING menu, press to enter Highlight “Auto off”, press to enter
Step 5 Step 6
Move Joystick to highlight “Off”, press to Move Joystick leftwards back to MODE
activate menu. Press camera “Shutter” or “Video
Recording” button to standby mode
Page 2
Set the DV Camera to Diving Mode before Installing to Underwater Housing :
The Special Diving Mode program installed in the DV Camera corrects the Mirrored Image
showed onto the Reflected Viewing Panel of the Underwater Housing which provides Normal
Views convenience for the user. To activate the Diving Mode , please follow the steps
mentioned below :-
Step 1 Step 2
Flip out the LCD panel (or press Turn the Display clockwise until it faces
the ON/OFF power button) to turn outwards, then flip it back to its original
on the DV Camera position with the Display facing outwards
Step 3 Step 4
Press the “ Playback “ Button until it KEEP ON pressing the “Playback” button
shows preview ready screen or your and then press the “Shutter ” button for
latest took image approx. 3 seconds until the image & all
icons are displayed in “mirrored “ images
Step 5 WARNING (Step 4) :
When running the “Diving Mode” Setting,
DO NOT press the “Playback” and “Shutter”
Buttons AT THE SAME TIME as this will
“FREEZE” all functions of the DV camera
and you will need to take out and re-install
the Lithium Battery Pack to reset the DV
camera
To turn the “Diving Mode” OFF after using the DV Camera with the Underwater Housing, simply
flip the Display Panel out and turn counter clockwise to its normal position, all images and
icons will return to its normal view.
Page 3
Mounting and Installing the DV Camera to Underwater Housing:
Step 1
Position the “Support Tray” to the mounting hole of the DV Camera, tighten the screw using
the hexagon key provided. Make sure the “Support Tray” is straightly aligned with the DV
Camera
Step 2 Step 3
Tie in the “Pulling Strap” to the strap hole Flip the LCD Panel back to the original
for pull out convenience of the DV Camera position with the display facing outward
Step 4
MAKE SURE to TURN ON the DV Camera, slide the DV Camera into the underwater housing thru
the “Guiding Slot” of the housing until it was fully inserted and securely seated
Step 5
Place the “Pulling Strap” buckle underneath the support tray
Page 4
Step 6
Clamp and slide the Locking Latch to securely close and lock the housing caseback.
Step 7
Slide and push the Safety Lock upwards to “ Lock “ position to prevent accidental opening of
the caseback underwater
Step 8
Flip the external Mirror View Panel outwards until it stops at approx 40 degree position
Step 9
Push the RED Locking Knob upwards to secure the Mirror View Panel in place and prevent it
from flipping back underwater due to the resistance of the water current
(Slightly flip the view panel backwards during push-to-lock process if you found it difficult to
lock the Locking Knob)
Loading...