Ultimate Support Systems IQ-200 User Manual

warranty registration

Visit www.ultimatesupport.com for a quick and convenient process for registering your new
Ultimate Support product. Warranty Registration and Proof of Purchase are required for warranty
fulfilment. Full Limited Lifetime Warranty and Ultimate Protection Plus Premium Service and
Support Plan details are available online under Music Gear & Instrument Stands / Customer Support.

Product Manual

for Ultimate Suppor t

800.525.5628 . www.ultimatesupport.com . Copyright 2010, Ultimate Support Systems . All Rights Reserved

4

IQ SERIES

®

2nd Tier Assembly for

IQ-1000 and IQ-2000

IQ- 200

ITEM # 13360

Revision 6, 03.21.09 . Product Manual Item #13360M

PARTS IN CLU DED IQ -2 00 SE TUP INST RUCT ION S (Contin u ed)

E.

D.

B.

C.

A.

IQ -2 00 SE TUP INST RUCT ION S

STE P 1

Remove rubber sleeves from back side of the
two top tubes of the IQ-1000 or IQ-2000.

STE P 3

A. (2) Tier Assemblies
B. (2) Small Friction Sleeves
C. (2) Z-nobs
D. (2) Washers
E. (2) Hex Nuts

Z-nobs, washer, and hex nuts are assembled together. Remove
hex nuts when adding to tier assemblies.

STE P 2

In preparation for STEP 3, use water and soap to
lubricate tube.

STE P 4

Plastic red
triangle

STE P 7

Install hand z-knob, washer, and hex nut. It
is important to place the hand knob on the
inside or stand will not fold fully. Also, be
careful not to over-tighten the hand knobs
because over-tightening may case cracking
of the collar.

IQ -20 0 T EAR DOW N I NST RUC TIO NS

STE P 1

STE P 3

STE P 8

Repeat steps 1-7 with other 2nd Tier Assembly.

Slide on Small Friction Sleeve to desired
position. Leave at lest 1.25” clearance from the
end of the tube for the 2nd Tier Assembly.

STE P 5 STEP 5

While holding the plastic red triangle, slide the
2nd tier into the top tube.

Make sure the plastic red triangle is at the joint.
This helps keep the joint open for sliding the 2nd
Tier Assembly into place.

Remove the plastic red triangle when Tier
Assembly is fully in.

Loosen z-knob until resistance is gone. You do
not have to completely unscrew for hex nut to
adjust second tier.

STE P 2

Pull tier to the outside of the IQ-1000
or IQ-2000.

Fold stand into closed position and push 2nd tiers in. Tighten
2nd tier z-knobs.

32