Ultimate Support MS-90-45R, MS-90-36R, MS-90-45B, MS-90-36B Users Manual

warranty registration

Visit www.ultimatesupport.com for a quick and convenient process for registering your new
Ultimate Support product. Warranty Registration and Proof of Purchase are required for warranty
fulfilment. Full Limited Lifetime Warranty and Ultimate Protection Plus Premium Service and
Support Plan details are available online under Music Gear & Instrument Stands / Customer Support.

Product Manual

for Ultimate Support

MS MKII

SERIES

MS-100R

ITEM #17381

MS-100B

ITEM #17451

MS-90/45R

ITEM #17380

MS-90/45B

ITEM #1745 0

800.525.5628 . www.ultimatesupport.com . Copyright 2011, Ultimate Support Systems . All Rights Reserved

4

MS-90/36R

ITEM #17430

MS-90/36B

ITEM #17449

MS-80

ITEM #173 79

MS-80

MS-100

MS-90/45

MS-90/36

Revision 1, 05.30.11 . Product Manual Item #MS-MKII-M

Column Assembly (MS-100 and MS-90)

Column Channels (MS-100 and MS-90)

1

2

3

Weight Channels

4

5

6 6

7

MS-100

1. Place rubber coupler on aluminum column.

Top View of Column

When placed properly, the larger weight
channel will be covered and the two cable
channels will be visible.

Cable
Channels

The column of the MS-100 and MS-90 all feature three channels.
Two of the channels are used for cables while the third, larger
channel is for filling with sand or shot.

2. With the feet caps facing up, set bottom
base on top of rubber coupler. When set
properly, the larger weight channel will
be completely covered and the two cable
channels will still be visible.

Top View of Column

It is best to keep audio and power cables separate from each
other, so run your audio cable down one channel and your power
cable down the other.

Fill the weight channel with sand or shot after point 4 in the
COLUMN ASSEMBLY section of instructions (see left). This weight

3. Hand tighten the four socket head cap
screws in base. Use provided 5mm allen

Weight
Channel

adds mass and eliminates sonic resonance.

wrench to finish tightening socket head
cap screws.

Socket Head Cap Screw

4. Turn column upside right. (If desired, add
sand or shot to the larger weight channel
at this point.)

5. Place second rubber coupler on the top
aluminum column. When placed properly,
the larger weight channel will be covered
and the two cable channels will be visible.

Adjustable Platform Setup (MS-100 and MS-80)

1

MS-100

1. AXIS ADJUSTMENT (MS-100): Instead
of moving the entire stand, you can
adjust the axis of the platform by moving
it in a circular motion clockwise or
counterclockwise until reaching the
desire position. NOTE: Be sure all four

MS-100MS-90

6. Set top base on column w/cable channels
still visible. Tighten the four countersink

2.1 2.2

screws in base using provided 4mm
allen wrench.

7. MS-100 ONLY: Place adjustable monitor
platform on top base, making sure feet

Countersink Screw

Angle Down Angle Up

3

spikes are securely set in indented holes
before placing studio monitors on top of

spikes are securely seated in indented
holes on base before placing studio
monitors on top of stand.

2. ANGLE UP OR DOWN: Your studio
monitors can angle up (2.1) or down
(2.2) depending on your situation.
Please choose and set before final
angle adjustment.

stand.

3. ANGLE ADJUSTMENT: Turn knob
clockwise or counter clockwise for

FOOTCAPS: Leave rubber foot caps on for placement on hard

precise angle adjustment.

wood floors or other such surfaces. Take them off and use
spikes for setting on carpet.

2 3