One-Hand Clutch Operation For MC-97 & MC-78
STEP 1
With your palm positioned on the lighter
gray cast side of the clutch, simply
squeeze the trigger to release the
internal friction mechanism.
STEP 2
While squeezing the trigger raise or
lower the clutch/upper shaft to your
desired height.
Die-cast
Clutch
Molded
Clutch
MCT-94T Boom Set-Up
Boom has “4 Degrees of Freedom”.
The boom adjusts front-to-back,
up-and-down, side-to-side and
rotationally. Simply untighten the
control knob, make all four adjustments and tighten snugly. To telescope, use smaller knob along boom
shaft to adjust the length.
Control
KNOB
MC-84 Boom Set-Up
Models: MC-84 Boom, MC-40,
MC-41T
The boom has 3-way adjustment:
front-to-back, up-and-down, and
rotationally. Simply untighten the control knob, make all three adjustments
and tighten snugly.
On MC-41T use smaller knob along
boom shaft to adjust the length.
Control
KNOB
3
STEP 3
Release the trigger and the internal lock
engages for a secure and reliable hold.
STEP 4
To adjust simply repeat STEPS 1 & 2.
When finished, lower the shaft to its
lowest position and release.
Stacking Base for Models MC-97 & MC-87
Stack 6 stands in the footprint of one.
Place stand one on the floor. Begin
stacking additional stands on top by
fitting the base cut-out around the
upright tubes of the stands. Turn the
bases so they interlock with the
stand underneath.
2
Standard Clutch: MC-87, MC-85, MC-40, MC-41T, MC-05
Turn the ergonomic clutch a quarter turn. Adjust stand height up or
down and securely retighten clutch.
Leg Replacement on MC-85 Series Stands
The legs on MC-85 Series Mic Stands are built to be extra durable,
withstanding the rigors of everyday use. However, if a leg should break
off, the stand is designed to be field repairable and the legs can be
replaced. Please visit www.ultimatesupport.com and click on Music
Gear & Instrument Stands > Customer Support > Limited Lifetime
Warranty to obtain warranty support information. Or call customer
support at 800-525-5628 for more details.