Ultimate Support IQ-X-3000 Users Manual

warranty registration

Visit www.ultimatesupport.com for a quick and convenient process for registering your new
Ultimate Support product. Warranty Registration and Proof of Purchase are required for warranty
fulfilment. Full Limited Lifetime Warranty and Ultimate Protection Plus Premium Service and
Support Plan details are available online under Music Gear & Instrument Stands / Customer Support.

Product Manual for Ultimate Support

IQ SERIES

®

KEYBOARD STAND

IQ-3000

ITEM #14036

800.525.5628 . www.ultimatesupport.com . Copyright 2010, Ultimate Support Systems . All Rights Reserved

4

IQ-1000

ITEM #13231

Load Capacity:
100 lbs. (45.5 Kg )

IQ-2000

ITEM #13241

Load Capacity:
150 lbs. (68.2 Kg )

Revision 6, 03.21.09 . Product Manual Item #14036M

Load Capacity:
300 lbs. (136.1 Kg)

IQ - 3000 SE T UP INSTRUCTIONS IQ -1000 / IQ -2000 SETUP INSTRUCTIONS

STEP 1

STEP 2

STEP 3

STEP 4

1. Stand the IQ-3000 upright with longer tubes on the floor and
Memory Lock facing you. Open the IQ-3000 up about 12".

2. Loosen Memory Lock knob by turning it counter-clockwise
about five (5) complete turns (being sure not to over loosen).

3. Holding Memory Lock front plate in left hand and back plate
in right hand, rotate plates in opposite directions and align
“hash marks” to set desired height setting. There are nine
(9 ) height options.

4. Tighten Memory Lock knob clockwise.

STEP 1

STEP 2

STEP 3

1. Set the IQ-1000 or IQ-2000 upright so that the longer leg
tubes are on the floor. Fully open the stand to the pre-set
position (there should be a noticeable resistance as the
plate catches the leg detent).

2. With the Memory Lock facing you, hold top left tube with
left hand and with your right hand pull the Memory Lock
knob toward you, being sure to fully retract the pin from
the Memory Lock plate.

3. Holding the extracted Memory Lock pin with right hand, pivot
the “X” brace with left hand to desired height and release pin.
Be sure the Memory Lock is fully and securely engaged before
placing keyboard on stand.

NOTE: Your IQ-1000 or IQ-2000 will open to this height every
time you use it unless a new height is desired. Repeat steps
1-3 to change height setting.

STEP 5

5. Open IQ-3000 fully.

NOTE: Your IQ-3000 will open to this height every
time you use it unless a new height is desired.
Repeat steps 1-5 to change height setting.

ADJUST ING END CAPS

IQ-3000/IQ-2000/IQ-1000

STEP 1 - 3

1. Open stand to fully open position.

2. If stand rocks on an uneven surface, turn black end cap
on bottom tube to a different thickness to correct.

3. End cap on top tube can also be adjusted to secure keyboard.

32