Ultimate Support HYP-100B User Manual

Visit www.ultimatesupport.com for a quick and convenient process for registering your new Ultimate Support product. Warranty Registration and Proof of Purchase are required for warranty fulfilment. Full Limited Lifetime Warranty and Ultimate Protection Plus Premium Service and Support Plan details are available online under Music Gear & Instrument Stands / Customer Support.
Product Manual
for Ultimate Support
HYPERPAD
HYP-100B
ITEM #17480
Pole Clamp
Top of Mic Stand
800.525.5628 . www.ultimatesupport.com . Copyright 2012, Ultimate Support Systems . All Rights Reserved
Page 4
Revision 1, 08.26.12 . Product Manual Item #HYP-100B-M
Desktop Clamp
Landscape View Stand
Portrait View Stand
Attaching iPad into HyperPad
(Two Steps)
Using HyperPad with Pole Clamp
(Four Steps)
1.
1. Push in triangle while pulling up on HyperPad mount clip to release.
Landscape and Portrait View
1.
1. Adjust standing angle by pulling the support leg out to desired position.
Using HyperPad with Table Clamp
1.
2.
2. Slide iPad into HyperPad mount until the clip “clicks” into place. Follow step one to remove.
(Two Steps)
2.
Bumper support
Bumper support
2. Rotate support leg into landscape or portrait view. For portrait view, flip out small bumper supports.
(Four Steps)
2.
1.
1. Attach clamp to lower tube of mic stand. Turn large knob to tighten and secure.
3.
3. Attach HyperPad to gooseneck by turning clockwise until tight.
Using HyperPad with Top of Mic Stand
1.
2.
2. Attach gooseneck onto clamp by turning it clock­wise until tight.
4.
4. Attach iPad onto HyperPad by following steps 1-2 in the “Attaching iPad into HyperPad” section.
(Three Steps)
2.
Large Knob
Small Knob
1. Turn large top knob to secure clamp to table. Turn small knob (bottom) for precise security.
3.
3. Attach HyperPad to gooseneck by turning clock­wise until tight.
Page 2
2. Attach gooseneck onto top of clamp by turning it clockwise until tight.
4.
4. Attach iPad onto HyperPad by following steps 1-2 in the “Attaching iPad into HyperPad” section.
1. Attach gooseneck onto top of mic stand by turning it clockwise until tight.
3.
3. Attach iPad onto HyperPad by following steps 1-2 in the “Attaching iPad into HyperPad” section.
2. Attach HyperPad to gooseneck by turning clock­wise until tight.
Page 3
Loading...