U-Line Pure Flow 1000 H-1297, Pure Flow 1000 S-11507 Installation Manual

Para Español, vea páginas 5-8.

Pour le français, consulter les pages 9-12.

π H-1297, S-11507

®

PURE FLOW 1000

1-80 0-295-5510

uline.com

EYEWASH STATION

GENERAL INFORMATION

The H-1297 shipping carton should contain:

• Eye Wash Station

• Emergency Sign

• Hanging Bracket

Before installing S-11507 Pure Flow 1000® Saline Cartridges, inspect product for damage.

NOTE: S-11507 Pure Flow 1000® Saline Cartridges are sold separately.

CARTRIDGE INSTALLATION

NOTE: This eyewash station requires two saline
cartridges to be installed at the same time.

1. Close the drain spigot by turning handle to the rear.
(See Figure 1)

2. Remove cover by lifting up. (See Figure 2A) Open
activating door. (See Figure 2B)

Figure 1

Open

Closed

Figure 2A

Cover

Figure 2B

Activating Door

PAGE 1 OF 12 0915 I H -1297

CARTRIDGE INSTALLATION CONTINUED

3. Raise reservoir to "Up" position, latch on housing by
pressing back on latching tabs. (See Figure 3)

4. Place two S-11507 Pure Flow 1000® Saline Cartridges
on the shelf. Nozzle assembly must be in front.
(See Figure 4)

Figure 3

Latching

Tabs

Reservoir

Figure 4

5. Pull green latch tabs forward to drop down reservoir,
ensuring that plates are seated on bags and are not
resting on the cartridge boxes. (See Figure 5)

6. Replace cover. (See Figure 6)

Figure 5

Reservoir

Plates

Figure 6

PAGE 2 OF 12 0915 I H -1297

CARTRIDGE INSTALLATION CONTINUED

7. Remove rubber bands from activating strap and
nozzle. Extend activating straps to the side. Do not
pull on the straps. (See Figure 7)

8. Snap right-hand nozzle into place on white nozzle
plate. An audible 'click' will be heard to confirm that
the nozzle is engaged. (See Figure 8)

Figure 7

Figure 8

9. Snap left-hand nozzle into place on white nozzle
plate. An audible 'click' will be heard to confirm that
the nozzle is engaged. (See Figure 9)

10. Position the two black straps over top of the
activation door with the expiration date and batch
number visible. Do not twist or cross straps. Close
activation door. (See Figure 10)

Figure 9

Figure 10

PAGE 3 OF 12 0915 I H -1297

CARTRIDGE INSTALLATION CONTINUED

11. Position nozzle activating straps over top of door and
down raised area on either side of the door handle
so the straps cover the labels on the activation door.
(See Figure 11)

12. Push plastic fastener into hole in door until flange is
seated against the door. (See Figure 11)

13. Push center pin of fastener until it snaps into place
flush with fastener head. (See Figure 11)

14. Position tamper seal on middle right-hand side of
door. Half the seal must be on the door and the
other half on the unit surface. (See Figure 12)

15. Attach lock or inspection tag through tab on cover.
(See Figure 12)

Fig ure 11

Figure 12

Center Pin

Plastic Fastener

Tab

Inspection

Tag

Tamper

Seal

π

CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA

1-800-295-5510

PAGE 4 OF 12 0915 I H -1297

uline.com