U-Line Echelon 2115WCOL, Echelon 2175WCOL, 2175BEVOL, 30139 Installation Instructions Manual

Overlay Door Panel
Installation Instructions for
Wine Captain Models
2175WCOL and 2115WCOL

Phone [phone] • FAX [phone]

Service & Parts Tech Lines Phone [phone] • FAX [phone]

www.U-LineService.com

[e-mail]

©2006 U-Line Corporation

04/2006

Overlay Panel Kit Parts Supplied Prepare the New Overlay Panel

Refer to the Overlay Panel Preparation instruction sheet,

Item Part

Number

1 12029-BLK Top Pivot Plate - Black 1

2 12041 Insert 8mm Plug 2

3 20002 Screw #6 x 1.0 Pan HD 10

4 30138

5 30139

6 31672 Door Closer - Male 1

7 31673 Door Closer - Female 1

8 35003

9 35003

10 42096 Pivot Post 2

11 42122 Screw #6 x .50 Lg Flat HD 2

Description Quantity

Mounting Instructions,
21XX (not shown)

WC Overlay Prep Sheet,
21XX (not shown)

Foam Tape .093 x .375 x
8’ (not shown)

Zipper Bag (holding
closer ASM) (not shown)

1

1

1

1

part number 30139.

IMPORTANT

The overlay door panel must not weigh more than
20 lbs. The thickness of the door panel must be 3/4".

Remove Gasket from Door

1. Remove door from shipping box.

2. Turn door over so gasket is facing up. Pull door gasket
out of the groove completely. Start in the middle and
pull outward, moving toward the edge

(Figure 2)

may take some force, but be careful.

DOOR

GASKET

. This

Figure 1

ULIN_0412_A

Figure 2

ULIN_0414_A

3. Place gasket on a flat, clean surface.

Checking Overlay Fit

CAUTION

If panel does not seat properly, determine the cause
of the problem by reviewing the Preparation
Instructions P/N 30139.

NOT FULLY SEATED LITTLE OR NO GAP OBJECTIONABLE GAP

Figure 3

1. Lay overlay panel on front side of door. Make sure
panel is fully seated on all four sides.

2. Visually check for gap between panel and glass. If there
is an objectionable gap, continue to

Tape t o Ove r l a y

.

Applying Foam

3. If there is little or no gap between panel and glass,
continue to

Attaching the Overlay Panel

ULIN_0415_A

.

www.U-LineService.com 2 04/2006