UEi CLM100 Instruction Manual
CLM100
Cable Length Meter
1-800-547-5740
www.ueitest.com • email: info@ueitest.com
INSTRUCTION MANUAL
ENGLISH
TABLE OF CONTENT
3
3
3
3
4-5
4
4
5
5
6
7
8
8
8
8
Introduction
Features icludes
Safety Tips
International Symbol
Instructions
Calibration Procedures
Measuring Length of Wire
Low Battery Indication
Measuring Resistance
Specifications
Operational Hints
Warranty
Disposal
Cleaning
Storage
3
The CLM100 Cable Length Meter is ideal for measuring cable length on the spool or in existing conduits.
Includes test leads, copper calibration bar, an abrasive pad for removing oxidation and carrying case.
Features include
• 3 digit display with enunciators
• Measures in FEET (ft) or METERS (m)
• Measures COPPER (CU) or ALUMINUM (AL) wire
• Resistance range for milliohm measurements
• Automatic temperature compensation
• User calibration mode. Calibration standard included
• Auto power off
WARNING!
Make sure wire under test is not energized. Never apply voltage to inputs.
NOTE: Temperature affects accuracy of readings. Please see accuracy specifications. For best results, allow the CLM100
to attain the same ambient temperature as the wire under test. The length of time this will take depends on the ambient
temperature. Typically it will take 10 to 15 minutes for the CLM100 to attain equal ambient temperature.
INTRODUCTION
Before using this meter, read all safety information carefully. In this manual the word “WARNING” is used to
indicate conditions or actions that may pose physical hazards to the user. The word “CAUTION” is used to
indicate conditions or actions that may damage this instrument.
SAFETY TIPS
INTERNATIONAL SYMBOLS
Dangerous Voltage Ground
AC Alternating Current
Warning or Caution
DC Direct Current
Double Insulation
(Protection Class ll)
Either AC or DC Fuse
Not Applicable to
Identified Model
Battery
Loading...