Udisense Nanit N151 Users manual

https://www.nanit.com/legal/compliance

“Nanit Plus” Camera (N151)

FCC Compliance Notice

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of FCC rules. Operation is subject to
the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including
interference that may cause undesired operation.

Change or modifications that are not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.

FCC RF Exposure Information

This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. In order to avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity
to the antenna shall not be less than 20cm during normal operation.
This device must not be collocated or operating in conjunction with
any other antenna or transmitter.

Industry Canada Compliance Notice
This device complies with Industry Canada license-exempt RSS

standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference
that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003.
Restrictions:
The device could automatically discontinue transmission in case of

absence of information to transmit, or operational failure. Note that this
is not intended to prohibit transmission of control or signaling
information or the use of repetitive codes where required by the
technology.

The device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel
mobile satellite systems;

This equipment complies with IC RSS-102 radiation exposure limits
set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance of 20 cm from all
persons.

IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits

set forth for an uncontrolled environment. This equipment should be