Quick Start EVK-M8xZOE
1. Overview
H (RF IN,
simulator)
G (20 pin
connector)
E (Boot)
F (RST)
D (SPI or RS232/USB switch)
active antenna)
A (RF IN,
Plastic
protection cover
B (USB)
C (RS232)
2. Setup
1. Download the EVK-M8xZOE software (and documentation) from www.u-blox.com/evaluation-kits
and install the software. For more instructions, see
the section 5, Installation.
2. Connect the unit to the PC. Options:
• USB: Connect via USB port (B). Set switch (D) to
RS232/USB.
• UART: Connect via RS232 (C). Set switch (D) to
RS232/USB.
Note: The Windows system will automatically search
for and install the USB driver.
3. Provide power to the device at all times, either via
USB or the V5_IN pin on the 20-pin connector (G).
4. Connect active GNSS antenna signal to EVK via RF IN
active antenna (
RF IN simulator (H).
5. Start the u-center GNSS Evaluation Software and
select the corresponding COM port and baud rate
(9600 baud).
A) or connect simulator to EVK via
Copyright © 2017, u-blox AG
3. Kit includes
• EVK-M8GZOE or EVK-M8BZOE unit
• USB cable
• Active GNSS antenna with a
3 m cable
4. Interfaces
The EVK-M8GZOE enables evaluation of
all interfaces available on ZOE-M8G and
ZOE-M8Q; while the EVK-M8BZOE is for
evlauation of all ZOE-M8B interfaces.
The EVK-M8xZOE provides a Micro
USB connector for communication
and powering the device, as well as
a RS232 for connecting to the COM
port of your PC.
Additionally, the EVK-M8xZOE supports DDC interface (I
and SPI interface for communication
with a host CPU.
2
C compliant)
5. Installation
Notes for downloading the EVK- M8xZOE
software package and running the
installation:
• An Internet connection is required.
• Supported Windows operating
systems: Windows 7 onwards (x86
and x64 versions)
• Choose a package: “Software only”
or “Software and documentation”.
• Unzip the downloaded file, go to
the Tools folder, and open the latest
version of the u-center zip file.
• Run the extracted u-center exe file
and follow the installer instructions.
• When the installation is complete,
you will find a u-center menu under
the Windows Start button:
All Programs > u-blox
6. u-center
The u-center GNSS evaluation software provides a powerful tool for
evaluation, performance analysis and
configuration of u-blox positioning
products.
7. More information
NOTE: Refer to recommendations in
the EVK-M8GZOE or EVK-M8BZOE user
guide when using the EVK-M8xZOE
with a GNSS simulator.
For more information regarding the
EVK-M8GZOE and the EVK-M8BZOE,
contact your nearest u-blox support:
(www.u-blox.com/en/
contact-us-support.html).
UBX-17013022 - R02
Loading...