Ubiquiti NanoBridge M NB-2G18-HP, NanoBridge M NB-5G25-HP, NanoBridge M5HP NB-5G22-HP Quick Start Manual
High-Performance
airMAX™ Bridge
Models:
NB-2G18-HP, NB-5G25-HP
1
Introduction
Introduction
Thank you for purchasing the Ubiquiti Networks™ NanoBridge™.
This Quick Start Guide is designed to guide you through the
installation of the NanoBridge and show you how to access
the airOS™ Configuration Interface. This Quick Start Guide is
for use with the NanoBridgeM2HP, model NB-2G18-HP, and the
NanoBridgeM5HP, model NB-5G25-HP.
Package Contents
or
Dish Reflector NanoBridgeM2HP
Antenna Feed
NanoBridgeM5HP
Antenna Feed
High-Performance
airMAX
™
Bridges
Models:
NB-2G18-HP, NB-5G25-HP
Rear Housing Dish Bracket Pole Clamp Quick Start Guide
M8 U-Bolt M8 Locknuts
(Qty. 2)
PoE Adapter
(24V, 0.5A)
Power Cord
2
NanoBridge
™
M2/M5HP Quick Start Guide
LEDs
Signal The first LED is lit red when the
wireless signal strength is above -94 dBm,
and the second LED is lit amber when the
wireless signal strength is above -80dBm.
The third LED is lit green when the wireless
signal strength is above -73 dBm, and the
fourth LED is lit green when the wireless
signal strength is above -65 dBm.
Ethernet The Ethernet LED is steady green
when an active Ethernet connection is made
and flashes when there is activity.
Power The Power LED is steady green
when the NanoBridge is connected to a
powersource.
Note: In airOS, you can modify the threshold values for each
LED on the Advanced tab under Signal LED Thresholds.
Installation Requirements
• 13 mm or ½" wrench
• Shielded Category 5 (or above) cabling should be used for all
wired Ethernet connections and should be grounded through
the AC ground of the PoE.
We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
3
Installation
Installation
The installation instructions show the NanoBridgeM2HP; however,
the same instructions apply to the NanoBridgeM5HP.
1. Line up the three tabs of the Dish Bracket to the three slots of
the Dish Reflector using the orientation shown below. Insert the
tabs and rotate the Dish Bracket until the tabs lock into place.
2. Line up the alignment tabs of the Rear Housing with the slots
of the Dish Reflector using the orientation shown below. Insert
the Rear Housing into the Dish Reflector and push until it locks
into place.
4
NanoBridge
™
M2/M5HP Quick Start Guide
3. Insert the Antenna Feed into the Rear Housing using the
orientation shown below and push until it locks into place.
4. Connect the Ethernet cable by performing the following steps:
a. Push in the tabs of the cable door and detach it from the
Rear Housing.
b. Connect an Ethernet cable to the Ethernet port of the
Antenna Feed.
c. Re-attach the cable door to the Rear Housing.
Loading...