Ubiquiti MFI-DS Quick User Guide

Door Sensor

Model: mFi-DS

Introduction

Thank you for purchasing the Ubiquiti mFi mFi-DS is designed for use with

the mFi mPort. Once they are

connected, you can use the mFi Controller software to monitor your sensors using your Web

browser.

™

Door Sensor. The

Hardware Overview

Magnet

Switch

Screw

Terminals

Switch Features Screw Terminals

and attaches to the frame of the

door or window.

Magnet Attaches to the door or

movable part of the window.

Installation Requirements

• mFimPort

• 2.4 mm Flathead Screwdriver

• Phillips Screwdriver (Optional)

Installation Tips

• For optimal performance, use one of these end-to-end configurations:

• Do NOT use an offset or T-shaped

configuration:

• The maximum gap is 20 mm.

Max. 20 mm

• On a door, we recommend that

you install the mFi-DS as high up as possible, either at the top or on

the side opposite of thehinges.

Ubiquiti Networks Support

Email: support@ubnt.com

Phone: 408-942-1153

(9 a.m. - 5 p.m. PST)

Online Resources

Wiki Page: wiki.ubnt.com

Support Forum: forum.ubnt.com

Downloads: downloads.ubnt.com

www.ubnt.com

JL070212

Door Sensor

Model: mFi-DS

Wiring Instructions

Perform these steps to connect the wire from the Switch to the mPort:

1. Insert each pre-stripped wire at one end of the 22AWG Double

Wire into each Screw Terminal.

2. Tighten each Terminal Screw.

3. On the other end of the 22AWG

Double Wire, repeat steps 1-2 to connect the wire to the I and O Terminals of the Terminal Block

that is included with the mPort.

4. Connect the Terminal Block to the Terminal Block Port (labeled Port 3 on the mPort).

Mounting Instructions

You have two mounting options available:

• Use the self-adhesive.

• Use a Phillips screwdriver and the

3 x 12 mm Mounting Screws.

1. Mount the Magnet onto the door or movable part of the window.

2. Align the Switch with the

Magnet so their edges line up when the door or window is

closed.

3. Mount the Switch onto the frame of the door or window.

Refer to the User Guide on the

CD-ROM that was included with

your mFi mPort for instructions on configuring the mFi-DS in the mFi

Controller software. The User Guide is also available at

www.ubnt.com/mfi