Carrier Class
AirMax BaseStation
Models: M3/M365/M5
Introduction
Introduction
Thank you for purchasing a PowerBridge M series product. This is a point-to-point CPE wireless device. This Quick Start Guide is for use with the following models:
Model |
Operating Frequency |
|
|
PowerBridge M3 |
3300 MHz-3700 MHz |
|
|
PowerBridge M365 |
3650 MHz-3675 MHz |
|
|
PowerBridge M5 |
5170-5875 MHz* |
|
|
* Only 5745-5850 MHz is supported in the USA and Canada
Package Contents
PowerBridge |
24V PoE |
Power Cord |
Antenna Bracket |
|
|
Adapter |
|
Clamps (Qty. 2) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pole Bracket |
Serrated |
Serrated Flange |
M8X135 |
Quick |
Clamps (Qty. 2) |
Flange Bolts |
Lock Nuts |
Carriage Bolts |
Start |
|
(Qty. 4) |
(Qty. 4) |
(Qty. 4) |
Guide |
Installation Requirements
•Adjustable wrench or one 16 mm and one 24 mm wrench
•Flathead screwdriver
•Shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.
We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
1
PowerBridge
Hardware Installation
To install the PowerBridge, perform the following steps:
1.Use a flathead screwdriver to unlock the PowerBridge case. Turn the screw counter-clockwise until it is loose. The screw remains attached to the compartment.
2.Lift the cover on the PowerBridge by pressing down and raising it up. Connect an Ethernet cable. There is an opening for the Ethernet cable. Slide the cover over the cable and secure it with the screw.
2
Hardware Installation
3.Insert the M8X135 Carriage Bolts into the Antenna Bracket Clamps.
4.Connect the Antenna Bracket Clamps to the PowerBridge using the four Serrated Flange Bolts.
RoHS
3
PowerBridge
5.Mount the PowerBridge to the pole by performing the following steps:
a.Position the PowerBridge in the desired mounting location on the pole.
b.Slide the Pole Bracket Clamps on to the Carriage Bolts.
c.Use the four Serrated Flange Lock Nuts to secure the PowerBridge to the pole.
RoHS
4