High-Performance airMAX® Omni
Model: LBE-M5-OMNI
Introduction
Thank you for purchasing the Ubiquiti Networks® LiteBeam™ Omni. This Quick Start Guide is designed to guide you through installation and also includes warranty terms.
Package Contents
Antenna |
Rear |
Mounting |
Pole Clamp |
|
Feed with Omni |
Housing |
Bracket |
|
|
U-Bolt |
Bolts (Qty. 4) |
Flange Nuts (Qty. 2) |
Washers (Qty. 2) |
|
Gigabit PoE (24V, 0.5A) |
Power |
Quick Start |
||
with Mounting Bracket |
Cord |
Guide |
Installation Requirements
•Phillips screwdriver
•10 mm wrench
•Shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.
We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable™ is designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic Frequency Selection (DFS) requirements.
Hardware Overview
Port View
RESET
Reset
Ethernet
Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the LiteBeam is already powered on. Alternatively, the LiteBeam may be reset remotely via a Reset button located on the bottom of the
Gigabit PoE adapter.
Release Button
Release Button
Release Button After you assemble the LiteBeam, check the Release button; it should be fully engaged in the Release Button Slot of the Rear Housing. This ensures that the Antenna Feed is locked into place. If you need to remove the Antenna Feed, you must depress the Release button first.
LEDs
Signal The default values (from left to right) are shown below:
LED will light blue when the wireless signal strength is equal to or above -65 dBm.
LED will light blue when the wireless signal strength is equal to or above -73 dBm.
LED will light blue when the wireless signal strength is equal to or above -80 dBm.
LED will light blue when the wireless signal strength is equal to or above -94 dBm.
Ethernet The Ethernet LED will light steady blue when an active Ethernet connection is made and flash when there is activity.
Power The Power LED will light blue when the device is connected to a power source.
Installation
1.Insert the Antenna Feed with Omni into the Rear Housing, and push until it locks into place with a click.
2.Connect an Ethernet cable to the Ethernet port of the
Antenna Feed.
*640-54321-01*
640-54321-01
3.Attach the Rear Housing to the Mounting Bracket with four Bolts.
4.Insert the U-Bolt into the Pole Clamp and Mounting Bracket. Secure each end of the U-Bolt with a Washer and a FlangeNut.
Note: The mounting assembly can accommodate a Ø 32 - 56 mm pole.