4G_USB_QSG_ash_p1p6.ai
logo grey
grahic1
graphic2
black
C:2 M:0 Y:9 K:36
C: M:0 Y: K:60
C: M:0 Y: K:90
C: M:0 Y: K:100
grahic3
graphic4
graphic5
graphic6
C: M:0 Y: K:70
C: M:0 Y: K:10
C: M:0 Y: K:30
C: M:0 Y: K:80
4G_USB_QSG_ash_p2p5.ai
C: M:0 Y: K:60
grahic1
C: M:0 Y: K:80
graphic2
C: M:0 Y: K:100
black
C: M:0 Y: K:70
grahic3
C: M:0 Y: K:10
graphic4
C: M:0 Y: K:30
graphic5
C:2 M:0 Y:9 K:36
logo grey
4G_USB_QSG_ash_p3p4.ai
C: M:0 Y: K:60
grahic1
C: M:0 Y: K:90
graphic2
C: M:0 Y: K:100
black
C: M:0 Y: K:30
graphic5
C:2 M:0 Y:9 K:36
logo grey
4G_USB_QSG_ash_p1p6.ai
r
r
logo grey
grahic1
graphic2
black
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible fo
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
C:2 M:0 Y:9 K:36
grahic3
graphic4
graphic5
graphic6
C: M:0 Y: K:70
C: M:0 Y: K:10
C: M:0 Y: K:30
C: M:0 Y: K:80
C: M:0 Y: K:60
C: M:0 Y: K:90
C: M:0 Y: K:100
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain
compliance with FCC RF exposure compliance requirements, please follow operation instruction as
documented in this manual.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Due to the essential high output power natural of WiMAX device, use of this device with other transmitte
at the same time may exceed the FCC RF exposure limit and such usage must be prohibited (unless such
co-transmission has been approved by FCC in the future).
SAR compliance has been established in typical laptop computer(s) with USB slot, and product could be
used in typical laptop computer with USB slot. Other application like handheld PC or similar device has
not been verified and may not compliance with related RF exposure rule and such use shall be
prohibited.
Loading...