Tysso BT series, BT-4500-K, BT-4500-R, BT-4500-U, BT-3800-K User Manual
...
Bluetooth Scanners
BT Series
User's Manual
-1-
Contents
1. Introduction 2
2. Available models 2
3. Standard package 3
5. Installation
........................................................
................................................
...............................................
4. Recharge............................................................ 4
(Receiver) ...................................... 5
6. Three operational modes................................... 9
7. Scanner programming....................................... 11
8. Purge scanned data from scanner...................... 13
(recapture mode only)
9. Audible & Visual Indicators and Operation...... 14
-3--2-
1. Introduction:
2. Available models:
The BT series incorporate Bluetooth wireless technology
which offers customers a freedom of mobility with up to
50 meters working range from receiver. The scanner is
configured to work as master mode, when it at Bluetooth
radio link on state, which makes attempts to connect with
receiver whenever the radio link breaks. With exceptional
power saving design, the scanner operates much longer
than your expectation on a full battery recharge circle.
Furthermore, user friendly operation and large memory
capacity characteristics give BT series a jump on its clone.
BT-4500-K (keyboard wedge)
BT-4500-R (RS-232)
BT-4500-U (USB)
BT-3800-K (keyboard wedge)
BT-3800-R (RS-232)
BT-3800-U (USB)
2.1. Extra Long Range CCD Scanner
2.2. Laser Scanne
·
·
·
·
·
·
r
3. Standard package:
BT-XXXX-X series
·
·
·
·
·
·
·
·
Scanner
Receiver
USB retrieving power cable
Utility CD disk
User's manual
Reader's external power adapter (option)
RS-232 interface receiver comes with PS/2 retrieving
power cable (default)
RS-232 interface receiver external power adapter
(option)
-4- -5-
5. Installation (Receiver):
BT series' paring between scanner and receiver is made
before shipment. So, normal operation can be started after
installation of the receiver to host computer.
Turn off the host computer.
Disconnect the keyboard cable from host computer.
Connect the keyboard cable into the female 6-Pin DIN
connector which located at long cable of the receiver.
Connect the short cable of the receiver into the
keyboard port on the host computer.
Turn on the host computer.
5.1. BT-XXXX-K: Keyboard wedge interface
·
·
·
·
·
To PC keyboard port
To keyboard cable
4. Recharge:
Just plug in the USB retrieving power cable or reader's
external power adapter to DC jack of the scanner, as
drawings show, and push & hold the trigger for over 5
seconds, then the scanner is activated into recharging
mode (green LED keeps flash). It takes about 4 hours to
finish the complete charging process (green LED turns
steady). During the charging process, the scanner neither
reads a barcode nor sends data to receiver.
USB retrieving power cable
reader's external power adapter
Please do not push the trigger within 3 seconds after
USB retrieving power cable or reader's external power
adapter applys to scanner's DC jack to avoild scanner
acts abnomal behaviors.
When the scanner is acting strange manners which
doesn't perform by the above mentioned advice, just
disconnect and plug in the power device to scanner's
DC jack to start your job again.
Important notice:
·
·
Loading...