TYROLIT Hydrostress FZ-4S Operating Instructions Manual

Operating Instructions

Wall saw FZ-4S

Index 002

10987111 EN /16.11.2016

Page 2

Wall saw FZ-4S

TYROLIT Hydrostress AG
Witzbergstrasse 18
CH-8330 Pfäkon
Switzerland
Tel. [phone]
Fax [phone]

Congratulations!

With a Hydrostress unit from TYROLIT, you have chosen a tried and tested piece of equipment

which has been designed and built to leading technical standards. Only genuine TYROLIT Hy-

drostress replacement parts can guarantee quality and interchangeability. We are unable to ful-

l our warranty obligations if maintenance work is neglected or carried out unprofessionally.

Any repair work must be carried out by trained personnel only.

Our aftersales service is available to help ensure that your TYROLIT Hydrostress units remain in

perfect working order.

We hope that you enjoy untroubled and fault-free working with your TYROLIT unit.

TYROLIT Hydrostress

Copyright © TYROLIT Hydrostress

TYROLIT Hydrostress AG

Page 3

Wall saw FZ-4S

Safety

These instructions are just one part of the documentation which is supplied together with the
wall saw. These instructions go together with the «Safety Manual / System Description for Wall
Saws» to form a complete set of documentation.

DANGER

Failure to comply with the safety instructions in the «Safety Manual / System Manual» may re­sult in serious injury or even death.

X Please ensure that the «Safety Manual / System Description for Wall Saws» has been read and

understood in full.

DANGER
Cuts from the saw blade.

X Always wear protective gloves when working on the wall saw, particularly when working on

the saw blade.

X Always use the blade guard when operating the wall saw.

DANGER
Serious injury or material damage as a result of uncontrolled movements of the wall saw.

X Never connect or disconnect hoses while the drive unit is running.

1

TYROLIT Hydrostress AG

Page 4

Wall saw FZ-4S

Description

Wall saw system

The layout and functions of the wall saw systems are described in the «Safety Manual / System
Description for Wall Saws».

Wall saw

Components

1 Feed motor, swivel 6 Blade drive motor
2 Blade guard holder 7 Saw blade holder
3 Water connection 8 Name plate
4 Feed motor, travel 9 Chassis
5 Lock unit 10 Geared swivel arm

2

Typ
Masch.- Nr.
Gewicht.

Index
Baujahr

CH-8330 Pfäffikon ZH Made in Switzerland

371

56

8

10 9

4

2

2.1

2.2

TYROLIT Hydrostress AG

Page 5

Wall saw FZ-4S

Assembly / disassembly

Place the wall saw on the guide rail

1.

2.

3

3.1

TYROLIT Hydrostress AG

Page 6

Wall saw FZ-4S

Adjustment of the closure

A: Rotate as far as the stop.
B: Rotate back two notch positions.

Release the closure

1.

2. Perform the remaining assembly steps in reverse order.

click

click

A

B

3.2

3.3