TYLT CLOAK Screen Protection User Manual

Invisible Screen

STEP 1

Have your device ready
on a soft, lint-free towel.
Make sure the device
is OFF. Unpack your CLOAK
box so that your squeegee,
spray bottle and CLOAK
are ready.

STEP 2

Spray your fingers with the
solution. It is KEY
to easy application.
Your fingers should
ALWAYS be wet when
handling the CLOAK.

STEP 3

Carefully remove the
CLOAK screen protector.

CLOAK

Protection

HOW TO INSTALL

STEP 5

Keeping CLOAK steady
with 1 hand, lightly squeegee
from the center outwards
to remove excess solution and
air. Do not squeegee towards
openings such as
the microphone or speaker.
If fluid does get into these
areas, blot the fluid out with
a Q-Tip or towel. Using your
towel, lightly pat around the
edges to remove any solution
that was squeegeed out.

STEP 6

Wet the tip of your squeegee
using the solution, then squee­gee CLOAK again, applying
slightly more pressure this
time. Gently wipe away excess
fluid.

STEP 4

With the application
solution, spray the
sticky side of CLOAK so
that it is completely wet.
Carefully lay the CLOAK on
your device, going
edge to edge when
laying it down, and
slide it into place. We
recommend using any
cut-outs and edges as
a guide for placement.

STEP 7

Allow to set for 5 minutes.

STEP 8

Let your device sit for
1 hour with the power OFF.
It is normal during this time
to see corners or edges lift up.
Simply push them back down
and hold them for
15 seconds with moderate
pressure using your thumb
or palm. After an hour you can
use your device normally.

LIFETIME WARRANTY

We’ll replace your CLOAK any time for any reason.

FOR ALL WARRANTY CLAIMS:

Please contact TYLT customer service. Phone: [phone] Email: [e-mail]

iPhone is a trademark of Apple Inc., registered in the U.S. and other countries.