Tyco Safety Canada 00NB909 Users Guide

WLS909NB

Wireless Key

OPERATING INSTRUCTIONS

The WLS909NB wireless key allows you to
arm and disarm your alarm system, as well
as perform other keypad functions, from a
unit small enough to keep in your pocket.
Together with your installer, you can decide
which functions you wish to have accessible
from your portable key.

To activate any one of the four selected
functions, press and hold the appropriate
button for two seconds. Your installer will
indicate each function by applying a circular
label beside each of the four buttons.

four
option
buttons

Signals will not be received if the
key is not within the range of the
wireless receiver.

Some of the most commonly used functions are as follows:

Stay Arming

Press this button to arm your system in the Stay mode. All perimeter zones
will be armed, such as all window and door contacts, but the interior zones
will remain inactive, allowing you to stay on the premises without setting off
an alarm.

Away Arming*

Press this button to arm your system in the Away mode. Both the interior
and exterior zones will be armed, allowing you to exit the premises.

Disarm*

Press this button to disarm your system. You do not have to enter your
access code when you use the key to disarm the system.

Fire

Press this button to notify your central monitoring station of a fire condition.

Auxiliary

Press this button to notify your central monitoring station of a non-medical
emergency. Please discuss the functionality of this button with your installer.

WLS909NB

key
ring

Panic

Press this button to notify your central monitoring station of a situation
requiring the police, such as a break-in.

Other options are available. Please discuss all WLS909NB options with your
installer in order to program the best possible combination to suit your needs.

*NOTE: In the UK some restrictions may apply. Please contact your
installer for details.

Replacing WLS909NB Key Batteries

To replace the batteries, remove the screw on the back of
the key and carefully separate the two sides of the key’s
plastic casing. Remove the old batteries from between the

–

+

two metal clips. Insert the new batteries according to the
diagram at right and reattach the two sides of the key’s
plastic casing. The WLS909NB requires three batteries of
type LR44.

NOTE: The polarity of the batteries must be observed.

LIMITED WARRANTY

Digital Security Controls Ltd. warrants that for a period of twelve months from the date of purchase, the product
shall be free of defect in materials and workmanship under normal use and that in fulfilment of any breach of
such warranty, Digital Security Controls Ltd. shall, at its option, repair or replace the defective equipment upon
return of the equipment to its repair depot. This warranty applies only to defects in parts and workmanship and
not to damage incurred in shipping or handling, or damage due to causes beyond the control of Digital
Security Controls Ltd. such as lightning, excessive voltage, mechanical shock, water damage, or damage
arising out of abuse, alteration or improper application of the equipment.

The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other
warranties, whether expressed or implied and of all other obligations or liabilities on the part of Digital Security
Controls Ltd. This warranty contains the entire warranty. Digital Security Controls Ltd. neither assumes, nor
authorizes any other person purporting to act on its behalf to modify or to change this warranty, nor to assume
for it any other warranty or liability concerning this product.

In no event shall Digital Security Controls Ltd. be liable for any direct, indirect or consequential damages, loss
of anticipated profits, loss of time or any other losses incurred by the buyer in connection with the purchase,
installation or operation or failure of this product.

WARNING: Digital Security Controls Ltd. recommends that the entire system be completely tested on a
regular basis. However, despite frequent testing, and due to, but not limited to, criminal tampering or
electrical disruption, it is possible for this product to fail to perf orm as expected.

TM

© 1999 Digital Security Controls Ltd.
Printed in Canada 29004684 R001