Tyco R/C R3044-0920, R3045-0920 Instructions Manual
I.CONTENTS/FEATURES
• Vehicle
• Transmitter
Vehicle
1
ON/OFF switch
2
Battery door
3
Battery door latch
4
AA Battery adapter
5
Light-up eyes
Transmitter
A
Antenna
B
Battery door
C
Driving controls(left button)
D
Driving controls(right button)
E
Turbo button
Keep these instructions for future reference: as they
contain important information. IMPORTANT: Please read
all “Consumer Information” before operating your vehicle.
CAUTION:
Surfaces may become hot and cause burns
if electronics get wet. Do not operate vehicle through water
or snow.
Asst.N4097
R3044/R3045-0920
8+
CAUTION:
To prevent entanglement,
keep hair away from wheels.
a
I
O
A
1
B
2
C
3
D
4
E
5
II.BATTERY INSTALLATION
Note: Your vehicle can be used with a Tyco® R/C 9.6V NiMH
battery pack or 6 AA alkaline batteries.
Requires a Tyco® R/C 9.6V NiMH battery pack or 6 AA
alkaline batteries for vehicle and 2 AA alkaline batteries for
transmitter.
Though your vehicle can run on both 9.6V or 6 x AA
batteries, it will run up to 30% faster when using a
9.6V rechargeable battery.
Vehicle
9.6V NiMH battery pack
1.
Rotate the battery latches, as shown, to unlock the battery
cover. Swing the battery cover up and away from the vehicle.
2. Use a screwdriver (not included) to unscrew and remove
the AA battery adapter. Store in a safe place for later usage.
3. Insert the 9.6V NiMH battery pack (not included), with
polarity (+/-) as shown inside the battery compartment .
4. Plug the wire connector into the battery compartment as
shown.
5. Replace the battery cover.
6. Turn "ON" the Power Switch.
6 AA alkaline batteries
1.
Rotate the battery latches, as shown, to unlock the battery
cover. Swing the battery cover up and away from the vehicle.
2. Make sure the AA battery adapter is firmly in place. If it’s
not, position the adapter in the box and fasten it with the
screw.
3. Insert the 6 AA batteries (not included), with polarity (+/-)
as shown inside the battery compartment .
4. Replace the battery cover.
5. Turn "ON" the Power Switch.
Transmitter
1. Remove the battery cover as shown.
2. Install 2 AA batteries (not included), with polarity (+/-) as
shown inside the battery compartment.
3. Replace the battery cover.
Your transmitter is equipped with a special
automatic ON battery-saving feature. Just turn your
vehicle ON. Then push either transmitter control to
run and control your vehicle.
9.6V d.c. NiMH,
9,6V
6XAA
It is recommended that you use at minimum
a 700mAh rechargeable battery for best
performance.
Loading...