K Series
CORCOM Product Guide
General Purpose RFI Power Line Filters — Ideal for High Impedance Load
UL Recognized
CSA Certified
VDE Approved
K Series
The K series RFI power line filters are general purpose
common-mode and differential-mode filters. They are
effective in the control of line-to-line as well as line-toground RFI interference. The K series RFI filters are
particularly suited in applications where pulsed, continuous
and/or intermittent RFI interference is present. The EK
models meet the very low leakage current requirements of
VDE portable equipment, and (120 Volt) UL544 non-patient
medical equipment.
Electrical Schematics
30VK6C Model (Inductor in Ground Line)
K6
V
K1/EK1
V
VK7/EK7
VK3/EK3
Specifications
Maximum leakage current,each line-to-ground
Models EK Models
VK
@ 120 VAC 60 Hz: .5 mA .21 mA
@ 250 VAC 50 Hz: 1.0 mA .36 mA
Hipot rating (one minute):
line-to-ground 2250 VDC
line-to-line 1450 VDC
Operating frequency: 50/60 Hz
Rated voltage (max.): 250 VAC
Minimum insertion loss in dB:
Line-to-ground in 50 ohm circuit
Current Frequency-MHz
Rating .15 .5 1 5 10 30
VK Models
1A, 3A 15 30 38 50 50 50
2A, 5A, 10A 6 19 28 42 45 50
20A, 30A, 40A 6 19 28 42 45 50
60A 6 22 28 32 39 35
EK Models
1A, 3A 15 29 35 45 45 50
2A, 5A, 10A, 20A 8 19 25 38 40 45
Line-to-line in 50 ohm circuit
Current Frequency-MHz
60VK6 Model
Resistor location for reference only.
74
Catalog 1654001 Dimensions are in inches and Dimensions are shown for USA Cust. Svc.: 1-800-468-2023 www.corcom.com
Revised 05-07 millimeters unless otherwise reference purposes only. CORCOM Prods: 1-847-680-7400 www.tycoelectronics.com
specified. Values in italics
are metric equivalents. to change.
Specifications subject
Rating .15 .5 1 5 10 30
VK, EK Models
1A, 3A – – 48 55 50 35
2A, 5A, 10A –
20A
VK Models
30A, 40A 2 40 60 65 57 55
60A 13 49 67 57 53 53
EK Models
30A
.
Germany: 49-89-6089-0
6
6
30 50
–
30
6
30 50 30 30
6
30 30
50 30 30
CORCOM Product Guide
E
D
B
A
C
Blue
Blue
Brown
Green/Yellow
B
rown
EDB
Terminals:
No. 8-32 (5)
A
C
General Purpose RFI Power Line Filters — Ideal for High Impedance Load (Continued)
K Series
Case Styles
K1
Typical dimensions:
Terminals: .250 [
lot: .07 x .16 [
S
K3
6.35] (5) Holes: .07 [1.8] Dia.(4)
.8 x 4.1
1
RFI Power Line Filters
20EK1/20VK1
]
Mounting holes: .188 [4.78]Dia. (2)
10VK6
Typical dimensions:
Wire leads: 4.0 [
1.016] Min. Mounting holes: .188 [4.78] Dia. (2)
Typical dimensions:
Mounting holes: .188 [
4.78] Dia. (2) Torque 18±2 in.lb
Catalog 1654001 Dimensions are in inches and Dimensions are shown for USA Cust. Svc.: 1-800-468-2023 www.corcom.com
Revised 05-07 millimeters unless otherwise reference purposes only. CORCOM Prods: 1-847-680-7400 www.tycoelectronics.com
specified. Values in italics
are metric equivalents. to change.
Specifications subject
Germany: 49-89-6089-0
75