Electric Fryer User Manual
II. Technical Specification:
III. Operating Instruction:
Before using, please check whether the voltage of power supply is in conformity with
that in date plate, and whether user’s power switch and fuse are in conformity with the
request of machine’s power. The body must be earthed properly. Make sure the
potential terminal bolt (yellow is potential identification) is firmly connected with the
natural grounding device by the 1.5 mm2 wire.
Operation Step:
1. Fill edible oil into oil tank and oil deepness must be kept on the range of oil tank
marked with the height and the low.
2. Turn the thermostat on”0”position, cut off the time switch power supply.
3. Connect with fryer’s power supply and green power indicator is on. Turn the power
of the machine on and adjust temperature control to suitable temperature in
clockwise; at this time, yellow indicator is on and heating elements begin to heat.
When oil temperature reaches setting data, temperature control is power-off, yellow
indicator is off, and heating elements stop working. When oil temperature is down a
little, temperature control connects power supply automatically, yellow indicator is
on, and thermal tubes begin heating again. This procedure is circulating repeatedly
to ensure oil temperature keep on set temperature range.
4. When the temperature of oil reaches the setting data, you may start the object
operation. You may reset the thermostat temperature according to your technical
request. There are timing function with four kinds of fryers, you may turn the time
controller on and rotate time controller to set the operating time at your object
operation. When the setting time has come, the fryer ring for warning and cut off
the power automatically, at this time, the yellow indicator is off and the fryer stops
working.
5. With over-temperature protection function. The temperature will be gone up rapidly
when thermostat damaged or out of work, while over 240℃, the temperature limiter
which is back of the control box will cut off power automatically, machine stops