Page 1
Installation
Care & Cleaning
2009 Honda
CB300
Slip-o n Exha ust System wi th A-2 Canis ter
Part # 0 05-271040 2V
1. Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on the sidestand
or ideally a rear service stand.
2. Remove OEM heat shield.
3. Remove OEM Muffler assembly. Make sure gasket is
removed also.
4. Use the 6x14mm socket head cap screws and split lock
washers to loosely join the s-bend to muffler. Do not
tighten yet.
Care & Cleaning
Keep system free of dirt and moisture. Store in a cool, dry place. Make sure vehicle is
completely cool before maintenance.
Brushed Aluminum Canisters: Clean using a mild water based spray cleaner. Always
apply cleaner or polish with a soft, clean cloth.
Repack all road canisters every 3,000 miles. Part #005-10038
Repack all offroad canisters after every 10 hours of use. Part #005-10038MX
Parts List
Qty. Description Part Number
1 A-2 Muffler Canister 005-271-202M
1 Slip-On Tube 005-27104S
1 Muffler Canister Clamp 005-2C
1 HARDWARE KIT 005-271-3
1 Stainless X-Ring 005-7-2-A2
1 57mm Barrel Clamp 005-27-57MSH
1 34mm Spacer 005-S-34
4 6x14mm Sock et Head Cap Screw 005-SH614
4 6mm Split Lock Washer 005-WL6
1 8x50mm Socket head Cap Screw 005-SH850
1 8mm Flat Washer 005-W08
1 5mm Long Handle Ball End Hex Key 005-9-18610
1 T20 Torx Short Hex Key 005-9-15820
1 TBR Sticker Kit 015-10212
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualied
motorcycle technician. If you have any doubts as to your ability to install
this performance part, please consult with your local motorcycle dealer.
Read all instructions rst before starting installation. Make sure the
motorcycle and exhaust system are completely cool before starting the
installation. Also, make sure the bike is secure on a centerstand or ideally
a service lift during installation. Be sure to save all stock components for
possible use later.
5. Slide supplied barrel clamp over slip-on tube end.
6. Slide rubber lined muffler clamp over muffler assembly.
7. Attach muffler assembly to motorcycle using the supplied
bolt and spacer with the OEM nut. The spacer goes
between the clamp and mounting bracket.
8. Align muffler and tighten the 4 X-ring bolts.
9. Tighten muffler clamp and barrel clamp at slip-tube joint.
10. Double check all your work.
11. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run
the bike and enjoy. It is normal for some white smoke to
appear the first time you start the bike. This is packing/
manufacturing oil from inside the pipe burning off.
Check for gaps or leaks. If you find a leak, a little high
temperature silicon sealant should fix it. After 50 to 100
miles, recheck all fasteners for tightness.
Loading...