TwinStar 28MM468 Assembly Instructions Manual

ATTENTION

IF YOU HAVE ANY PROBLEMS OR QUESTIONS, EMAIL

OR CALL CUSTOMER SERVICE BEFORE YOU RETURN

THIS PRODUCT TO THE STORE WHERE IT WAS PURCHASED.

For Customer Service: www.twinstarhome.com

in English Call: 866-661-1218 in Spanish Call: 866-661-1218 in French Call: 866-374-9203

ATENCIÓN

SI TIENE ALGÚN PROBLEMA O PREGUNTAS,

ENVÍE UN MENSAJE DE CORREO ELECTRÓNICO O LLAME AL SERVICIO

DE ATENCIÓN AL CLIENTE ANTES DE DEVOLVER

ESTE PRODUCTO A LA TIENDA EN LA QUE LO COMPRÓ.

Servicio de atención al cliente: www.twinstarhome.com

Línea para llamadas en inglés: 866-661-1218 Línea para llamadas en español: 866-661-1218 Línea para llamadas en francés: 866-374-9203

STOP

PARE

ATTENTION

SI VOUS AVEZ DES PROBLÈMES OU QUESTIONS,

ENVOYEZ UN COURRIEL AU SERVICE À LA CLIENTÈLE OU APPELEZ LE

SERVICE À LA CLIENTÈLE AVANT DE RETOURNER

CE PRODUIT OÙ VOUS L’AVEZ ACHETÉ.

Pour le service à la clientèle : www.twinstarhome.com

pour le service en anglais, composez le 866-661-1218 pour le service en espagnol, composez le 866-661-1218 pour le service en français, composez le 866-374-9203

ARRÊT

INSTRUCTION MANUAL ENCLOSED

MANUEL D’INSTRUCTION À L’INTÉRIEUR

MANUAL DE INSTRUCCIONES ADJUNTO

INSTRUCTION MANUAL ENCLOSED

MANUEL D’INSTRUCTION À L’INTÉRIEUR

MANUAL DE INSTRUCCIONES ADJUNTO

WOOD MANTEL ASSEMBLY INSTRUCTIONS

WOOD FIREPLACE MANTEL

28MM468

E-1

Part Description Quantity

PARTS

HARDWARE

PARTS LIST

www.twinstarhome.com In English call: 866-661-1218 In French call: 866-374-9203 In Spanish call: 866-661-1218

For Customer Service:

A Hearth/Base B Center Left Side Panel C Center Right Side Panel D Center Front Panel E Left Side Panel F Right Side Panel G Mantel/Top H Wood Shelf I Left Back Panel J Left Front Door K Right Front Door P Right Back Panel X Glass Door Panel

Y

Speaker Grill Door Panel

L Bolt 1/4 in. x 1-1/4 in. 22 M Washer 1/4 22 N Wood Dowel 20 O Shelf Pin 16 Q Screw 24 V Knob(With Bolt) 2

1 1 1 1 1 1 1 4 1 1 1 1 1 1

33445

For a complete tight fit every bolt

should have a flat washer. First slide a

flat washer onto the bolt.

All panels are labeled Left and Right as viewed from the front of unit.

1. Locate the Center Left Side Panel (B), Center Right Side Panel (C), Center Front Panel (D), and set out face down on a scratch-free surface.

2. Insert one Wood Dowel (N) into each of the pre-drilled holes.

3. Push the Center Left Side Panel and Center Right Side Panel snug to the Center Front Panel. Make sure the Wood Dowels are seated in the pre-drilled holes. Insert Bolts (L) and Washers (M) into the holes in the mounting blocks.

HAND TIGHTEN ONLY .

E-2

PLEASE READ AND FOLLOW ALL SAFETY TIPS

GETTING STARTED

1. Before assembly, CAREFULLY use scissors or utility knife to cut and unwrap all parts. Make sure you do not discard the hardware.

HELPFUL HINTS

6RPHVWHSVDUHPRUHHDVLO\KDQGOHGZLWKWZRDGXOWV  Attach the fireplace insert to the completed wood mantel last. INSTALL INSERT IN FROM THE

BACK OF THE FIREPLACE SO AS NOT TO SCRATCH THE HEARTH/BASE. 8VHFDUHLQDVVHPEOLQJ\RXUQHZfireplace, take your time and use the hardware provided and a

quality Phillips head screwdriver. NEVER OVER TIGHTEN BOLTS.

CARE & CLEANING

1. Dust your fireplace regularly with a soft non-lint producing cloth or household dusting product.

2. You can clean your fireplace with a gentle non-abrasive household cleaner. Make sure to dry your

fireplace immediately with a soft cloth or towel.

2. Make sure that you have all the parts listed. If you are missing any parts please email Customer Service: www.twinstarhome.com or call 1-866-661-1218 in English, 1-866-374-9203 in French

or 1-866-661-1218 in Spanish. Please identify the parts you need and model number. Make sure to include your name and address.

'RQRWVLWRQDQ\SDUWRIWKHPDQWHO

CAUTION:

DO NOT MOVE MANTEL OR INSERT WHILE PLUGGED INTO POWER SUPPLY.

N

A

Center Front

Panel

D

C

B

L

M

Hearth/Base

Center

Left Side

Panel

Center

Right Side

Panel

Left Side Panel

Right Side Panel

Mantel/Top

N

M

L

M

L

F

E

G

A

N

4. Locate Hearth/Base (A) and set out finished side up on the floor.

5. Insert one Wood Dowel (N) into each of the pre-drilled holes.

6. Attach the Completed Center Front assembly from step 3 to the Hearth/Base (A). Make sure that dowels are seated into the pre-drilled holes in the Hearth/Base. Using Bolts (L) and Washers (M) attach panels through pre-drilled holes in the mounting blocks.

HAND TIGHTEN ONLY.

7. Locate Left Side Panel (E) and Right Side Panel (F), insert one Wood Dowel (N) into each of the pre-drilled holes on the bottom edge of the panels. Then use Bolts (L) and Washers (M) through the pre-drilled holes in the mounting blocks. Attach the Side Panels to Hearth / Base (A). HAND TIGHTEN ONLY.

Insert one Wood Dowel (N) into each of the pre-drilled holes on the top edges of the Assembly from step 7. Then locat

e Mantel/Top (G) and lay finished side up on top of completed assembly. From the inside, attach Mantel/Top (G) using Bolts (L) and Washers (M) through the pre-drilled holes in the mounting blocks.

HAND TIGHTEN ONLY.

8.

E-4

9. Locate Left Back Panel (I), attached to the left back of the completed assembly from step 8, using a Phillips Head screw driver, screw Screws (Q) through the pre-drilled holes in the Left Back Panel to the completed assembly.

10. Locate Right Back Panel (P), attached to the right back of the completed assembly from step 8, using a Phillips Head screw driver, screw Screws (Q) through the pre-drilled holes in the Right Back Panel to the completed assembly.

I

Q

P

Screw

Left Back Panel

Right Back Panel

Glass Door Panel

X

Y

Wood Door

Speaker Grill Door Panel

11. If you are wish to use the Wood Door with this fireplace, please skip step 9 and proceed to step 10 of the installation.

This mantel comes with 3 types of door panels for your reference. The Wood Door Panel comes pre-installed. Follow the below-mentioned instructions in order to replace with Glass Door Panel (X) or Speaker Grill Door Panel (Y) .

a. Untighten screw from clips. b. Remove Wood Door panels from door frame. c. Replace with Glass or Speaker Grill door panels. d. Tighten the screw through the clips

O

H

Wood Shelf

Shelf

E-5

14. Choose desired height of Shelf (H) and place the four Shelf Pin (O) into same height shelf holes inside side panels. Insert Wood Shelf (H), allow Wood Shelf (H) to rest on the Shelf Pin (O).

15.Using Phillips head screwdriver tighten all Bolts alternating top and bottom,left and right.

12. Locate Right Front Door (K) and Left Front Door (J). Slide door hinge keyhole into panel hinge bracket. (Diagram 1) Use Phillips Head Screwdriver to tighten screws. (Diagram 2)

TO ADJUST HINGES

To adjust door forward or backward change keyhole slot position. (As Shown In

Diagram 3a)

To adjust door right or left loosen / tighten screw. (As Shown In Diagram 3b) To adjust door up or down adjust bracket height. (As Shown In Diagram 3c).

13. Attach the Knob (V) to the Left Front Door (J) and Right Front Door (K), use the bolts attached through the pre-drilled holes in the doors. Then use a Phillips Head Screwdriver to tighten the bolts.

J

K

1 2 3

a

b

c

Left

Completed Assembly

Front Door

Right Front Door

V

Knob

(with Bolt)

TwinStar 28MM468 Assembly Instructions Manual

Specifications and Main Features

Frequently Asked Questions

User Manual